Przejdź do treści
    OBD Tuning
    WYŚLIJ DO NAS
    WYŚLIJ DO NAS
    Strona główna
    Kody błędów
    VOLVO
    CEM-P165312
    VOLVO

    CEM-P165312 - Power Steering Output Circuit. General Electrical Failures. Circuit short to battery

    Układ

    Centralny moduł elektroniczny (CEM)

    Modele Volvo, których dotyczy ten kod błędu

    Dotyczy następujących modeli:

    7 modeli

    S60 (2011–), S80 (2007–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)

    Pokaż modele wg rocznika i silnika (7)
    • Volvo S60 (2011–)2011–2015
    • Volvo S80 (2007–)2007–2015
    • Volvo V60 (2011–)2011–2015
    • Volvo V60 Cross Country (2015–)2015
    • Volvo V70 (2008–)2008–2015
    • Volvo XC60 (2009–)2009–2015
    • Volvo XC70 (2008–)2008–2015

    Co oznacza ten kod błędu?

    The CEM sends a frequency-modulated signal to the speed-dependent power steering module (HPAS), and the signal wire is shorted to supply voltage. The voltage then stays constantly high, and the speed-dependent power steering may stop regulating. The fault applies to the V60, S60 and similar models that have this system.

    Możliwe przyczyny

    • The signal wire to the HPAS module is shorted to supply voltage

    Co możesz zrobić

    1. 1Start the engine and turn the steering wheel slowly from side to side. If it is stiff when the car is stationary, the fault is active
    2. 2Check the power steering module fuse in the engine bay relay and fuse box. If it has blown, check its circuit for a short to earth before replacing it
    3. 3Use a multimeter to check that the signal wire has no contact with supply voltage with the ignition on
    4. 4With a diagnostic tool, clear the fault codes and run a short test. If the fault returns straight away, it is active
    5. 5Steering is a safety function. Have a workshop repair the fault promptly rather than putting it off
    6. 6After the work, check that the steering wheel turns easily and that the fault code does not return

    Objawy, które możesz zauważyć1

    • The power steering assistance control does not work

    Na co może wpływać usterka2

    • The function switches off during the driving cycle in which the fault is detected
    • After 100 driving cycles with the fault present, the function is switched off permanently

    Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.

    OBD Tuning

    Wiodące centrum ekspertów Szwecji w elektronice motoryzacyjnej. Oferujemy profesjonalną optymalizację silnika, naprawę sterowników i diagnostykę z gwarancją 12 miesięcy.

    Usługi

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    Baza danych & Diagnostyka

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    Producenci ECU

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Firma

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    Odwiedź nas

    Gjuterigatan 29, Karlstad

    Zadzwoń do nas

    054-830 480

    Napisz do nas

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Wszelkie prawa zastrzeżone.