Przejdź do treści
    OBD Tuning
    WYŚLIJ DO NAS
    WYŚLIJ DO NAS
    Strona główna
    Kody błędów
    VOLVO
    CEM-U000111
    VOLVO

    CEM-U000111 - High Speed CAN Communication Bus. General Electrical Failures. Circuit short to ground

    Układ

    Centralny moduł elektroniczny (CEM)

    Modele Volvo, których dotyczy ten kod błędu

    Dotyczy następujących modeli:

    7 modeli

    S60 (2011–), S80 (2007–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)

    Pokaż modele wg rocznika i silnika (7)
    • Volvo S60 (2011–)2011–2015
    • Volvo S80 (2007–)2010–2015
    • Volvo V60 (2011–)2011–2015
    • Volvo V60 Cross Country (2015–)2015
    • Volvo V70 (2008–)2010–2015
    • Volvo XC60 (2009–)2010–2015
    • Volvo XC70 (2008–)2010–2015

    Co oznacza ten kod błędu?

    One of the high speed CAN wires is shorted to earth, which disturbs communication between the control modules. The engine may then have trouble starting, performance and throttle response can suffer, and the gauges may read wrongly. The fault most often lies in the high speed network wiring.

    Możliwe przyczyny

    • Short circuit between one of the CAN wires and earth

    Co możesz zrobić

    1. 1Note when the faults occur, for example at start, under acceleration or at steady speed. This gives a clue to where the cable is damaged
    2. 2Check that the high speed network harness is not chafed, pinched or worn against the body
    3. 3Check the connectors in the high speed network for loose connections, corrosion and moisture
    4. 4With a diagnostic tool, read the fault codes from all control modules and start with those for the CAN network
    5. 5Use a multimeter to check that the CAN wires have no contact with earth or the body along their length
    6. 6If the engine stalls while driving, avoid long journeys and have a workshop trace the fault promptly

    Objawy, które możesz zauważyć5

    • The engine does not start
    • Poor performance and lack of power, especially at take-off
    • The throttle response hesitates, surges or is jerky
    • Cruise control cannot be engaged
    • The speedometer and tachometer show wrong readings or do not work

    Na co może wpływać usterka1

    • The affected module stays switched off until its power supply is cut

    Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.

    OBD Tuning

    Wiodące centrum ekspertów Szwecji w elektronice motoryzacyjnej. Oferujemy profesjonalną optymalizację silnika, naprawę sterowników i diagnostykę z gwarancją 12 miesięcy.

    Usługi

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    Baza danych & Diagnostyka

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    Producenci ECU

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Firma

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    Odwiedź nas

    Gjuterigatan 29, Karlstad

    Zadzwoń do nas

    054-830 480

    Napisz do nas

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Wszelkie prawa zastrzeżone.