VOLVO
CRM-20E2 - Hall sensor 16. Short to GND, disconnected or internal error
Układ
Podwozie (Hamulce, układ kierowniczy, zawieszenie)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
1 modelC70 (2006–2013)
Pokaż modele wg rocznika i silnika (1)
Co oznacza ten kod błędu?
The power consumption of hall sensor 16 is above the normal value, and no sensor pulse appears when the hydraulic pump runs. The fault can be caused by the signal wire being shorted to ground, a broken connector between the sensor and the control module, or an internal fault in the sensor or in the roof control module.
Możliwe przyczyny
- The signal wire is shorted to ground
- The connector between hall sensor 16 and the roof control module is broken
- Internal fault in hall sensor 16
- Internal fault in the roof control module (CRM)
Co możesz zrobić
- 1With a multimeter you can check that the wire from hall sensor 16 has no break and no short to ground
- 2Check that the connector is clean, fully seated and free from loose connections
- 3Repair a damaged wire. If the connector and wire are intact but the fault remains, a workshop should replace hall sensor 16
- 4If the fault still remains, a workshop needs to check the roof control module
- 5Read out and clear the fault code, test the roof and see whether the fault comes back
Objawy, które możesz zauważyć2
- No or limited roof operation
- Message in the display
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.