VOLVO
DCDC-P060C00 - Internal Control Module Main Processor Performance. General Failure Information. No sub type information
Układ
Nieznany układ / Specyficzny dla marki
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
1 modelV60 (2011–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The control module for the DC/DC converter, which converts power from the high voltage battery to the car's ordinary electrical system, has found an internal fault in its main processor. The fault is generic and gives no further detail on the fault type. The code is tested when the ignition is switched on and is only stored when the fault is actually present. Because the converter is part of the high voltage system, charging of the high voltage battery is affected.
Możliwe przyczyny
- Internal fault in the DC/DC converter control module
Co możesz zrobić
- 1Switch the ignition off, wait a moment and switch it on again. Then check whether the warning has cleared
- 2Read and note the code, clear it and drive the car for a while to see whether it returns
- 3If the fault returns after a restart, have a workshop check the high voltage system and replace the control module if needed
- 4The high voltage system may only be handled by qualified personnel. Do not work on the converter or its wiring yourself
Objawy, które możesz zauważyć4
- Warning symbol and message in the display
- The high voltage battery does not charge, or charging is reduced while driving
- Drive modes PURE, SAVE and AWD disengage automatically or cannot be selected
- The combustion engine runs all the time or too often in HYBRID mode
Na co może wpływać usterka2
- The high voltage battery is not charged
- Hybrid drive mode is forced
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.