VOLVO
DCDC-P0A0916 - DC/DC Converter Status Circuit Low. General Electrical Failures. Circuit voltage below threshold
Układ
Nieznany układ / Specyficzny dla marki
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
1 modelV60 (2011–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The DC/DC converter control module has registered that its status circuit is too low, and the voltage is below the permitted range. The cause may be a short to ground or a break or poor contact in the connections. The code is tested when the ignition is switched on. Because the converter is part of the high voltage system, charging of the high voltage battery is affected.
Możliwe przyczyny
- Short circuit or open circuit in the connections
- Short circuit to ground
Co możesz zrobić
- 1Switch the ignition off, wait a moment and switch it on again. Then see whether the code comes back
- 2Check that the ordinary battery is fully charged and that its terminals are tight, since weak voltage in the electrical system can affect the converter
- 3Have a workshop check the supply and connections to the converter, and the ground point, for breaks, contact resistance and oxidation
- 4If the fault remains, have a workshop replace the control module. The high voltage system may only be handled by qualified personnel
Objawy, które możesz zauważyć4
- Message and warning symbol in the display
- The high voltage battery does not charge, or charging is reduced while driving
- Drive modes PURE, SAVE and AWD disengage automatically or cannot be selected
- Hybrid mode is forced and the combustion engine runs too often
Na co może wpływać usterka2
- No charging of the high voltage battery
- Hybrid drive mode is forced
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.