VOLVO
DDM-U040100 - Invalid Data Received from ECM/PCM A. General Failure Information. No sub type information
Układ
Moduł drzwi kierowcy (DDM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
5 modeliS60 (2011–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–)
Co oznacza ten kod błędu?
The driver or passenger door module continuously receives information about the outside temperature from the engine control module (ECM) and checks the quality of the signal. The fault is stored when the ECM reports a lower signal quality than the door module accepts. The door module then uses the temperature from its own built-in sensor instead.
Możliwe przyczyny
- The cause lies in the engine control module (ECM), which sends the signal
Co możesz zrobić
- 1Read the codes in the engine control module (ECM) with diagnostic equipment, as fault finding is done there
- 2Check that the fuses are intact
- 3Do not clear the code until the fault in the engine control module has been repaired, as the code will then return
- 4Check whether the engine control module has further fault codes that may give a clue
- 5If the fault remains, have a workshop repair the fault in the engine control module and then clear the code
Objawy, które możesz zauważyć1
- No noticeable symptoms for the driver
Na co może wpływać usterka1
- The door module uses the temperature from its own built-in sensor instead
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.