DEM-0003
VOLVO
DEM-0003 - System voltage. Faulty voltage
Układ
Moduł napędu na cztery koła AWD (DEM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
7 modeliS40 (2004–2013), S60 (2001–2009), S80 (1999–2006), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Pokaż modele wg rocznika i silnika (14)
- Volvo S40 (2004–2013)2005–2010Tylko skrzynia biegów: AW50/51 AWD, M66 AWD
- Volvo S60 (2001–2009)2003–2005Wszystkie skrzynie biegów oprócz: AW55-50/51SN
- Volvo S60 (2001–2009)2006–2008Wszystkie skrzynie biegów oprócz: AW55-50/51SN, TF-80SC
- Volvo S60 (2001–2009)2009Tylko skrzynia biegów: AW50/51 AWD, M58
- Volvo S80 (1999–2006)2003–2006Tylko skrzynia biegów: AW50/51 AWD
- Volvo V50 (2004–2013)2005–2010Tylko skrzynia biegów: AW50/51 AWD, M66 AWD
- Volvo V70 (2000–2008)2003–2005Wszystkie skrzynie biegów oprócz: AW55-50/51SN
- Volvo V70 (2000–2008)2006–2007Wszystkie skrzynie biegów oprócz: AW55-50/51SN, TF-80SC
- Volvo V70 XC / XC70 (2001–2007)2003–2007
- Volvo XC90 (2003–)2003–2004, 2006Wszystkie skrzynie biegów oprócz: AW55-50/51SN
- Volvo XC90 (2003–)2005Wszystkie skrzynie biegów oprócz: AW55-50/51SN, TF-80SC AWD
- Volvo XC90 (2003–)2007Wszystkie skrzynie biegów oprócz: AW55-50/51SN, TF-80SC
- Volvo XC90 (2003–)2008Wszystkie skrzynie biegów oprócz: TF-80SC
- Volvo XC90 (2003–)2009Tylko skrzynia biegów: AW50/51 AWD
Co oznacza ten kod błędu?
The four-wheel drive control module (DEM) compares its own supply voltage with the voltage in the central electronic control module (CEM). The code is stored when the two differ too much, which can be caused by a signal wire shorted to voltage or to ground, or by a break in the supply. The four-wheel drive is blocked or disengaged for as long as the fault is active.
Możliwe przyczyny
- Signal wire shorted to voltage
- Signal wire shorted to ground
- Break in the supply voltage
Co możesz zrobić
- 1Read and erase the code, then road test to see whether it returns
- 2Check that the fuses are intact
- 3If you have a diagnostic tool, read the four-wheel drive control module voltage at idle and compare it with the battery voltage; any difference points to the supply
- 4Check the wire to the connected unit for damage, and the connectors for oxidation and contact resistance
- 5If the fault is not active now but has been, it is probably intermittent; check the connectors carefully and watch whether it comes back
- 6If the code returns, have a workshop with diagnostic equipment check the supply voltage and replace the control module if needed
Objawy, które możesz zauważyć1
- The four-wheel drive does not work
Na co może wpływać usterka2
- The four-wheel drive is blocked
- The four-wheel drive is disengaged
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.