VOLVO
DEM-U210000 - Initial Configuration Not Complete. General Failure Information. No sub type information
Układ
Moduł napędu na cztery koła AWD (DEM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
8 modeliS60 (2011–), S80 (2007–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Co oznacza ten kod błędu?
The all-wheel drive control module (DEM) has not received the vehicle configuration it expects from the central electronic module (CEM), so the initial configuration has not been completed. The code is set when the information is missing after the ignition has been switched on. It is most often a communication fault on the car's data network.
Możliwe przyczyny
- Open circuit in the car's data network (CAN)
- Fault in the central electronic module (CEM)
Co możesz zrobić
- 1Read the codes in the central electronic module and other control modules, as they are often linked
- 2Check that the battery and its terminals are in good condition, since voltage drops can disturb the data network
- 3With diagnostic equipment check the data network and the connectors between the modules
- 4Do not replace the central electronic module until a workshop has investigated the data network and confirmed an internal fault
Objawy, które możesz zauważyć1
- No clear symptoms for the driver
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.