VOLVO
ECM-0341 - Camshaft position (CMP) sensor. Faulty signal
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
4 modeleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Pokaż modele wg rocznika i silnika (12)
- Volvo C30 (2007–2013)2007–2010Tylko silnik: B4164S3, D4204T
- Volvo C30 (2007–2013)2011–2012Tylko silnik: B4164S3
- Volvo C70 (2006–2013)2008Tylko silnik: D4204T
- Volvo C70 (2006–2013)2009–2010Tylko silnik: D4204T · Tylko skrzynia biegów: MMT6, MPS6
- Volvo S40 (2004–2013)2004Tylko silnik: D4204T, D4204T2
- Volvo S40 (2004–2013)2005–2006Tylko silnik: B4164S3, D4204T, D4204T2
- Volvo S40 (2004–2013)2007–2010Tylko silnik: B4164S3, D4204T
- Volvo S40 (2004–2013)2011–2012Tylko silnik: B4164S3
- Volvo V50 (2004–2013)2004Tylko silnik: D4204T, D4204T2
- Volvo V50 (2004–2013)2005–2006Tylko silnik: B4164S3, D4204T, D4204T2
- Volvo V50 (2004–2013)2007–2010Tylko silnik: B4164S3, D4204T
- Volvo V50 (2004–2013)2011–2012Tylko silnik: B4164S3
Co oznacza ten kod błędu?
The engine control module (ECM) compares the camshaft sensor signal with a calculated value. When the two do not agree at engine speeds above a certain level, the control module interprets this as a fault. The causes may be contact resistance, wiring faults, an incorrectly fitted or damaged camshaft sensor, or a damaged control module.
Możliwe przyczyny
- Contact resistance in the connections
- Open circuit or short circuit in the wiring
- Incorrectly fitted camshaft position sensor
- Damaged camshaft position (CMP) sensor
- Damaged engine control module
Co możesz zrobić
- 1Check that the camshaft sensor is correctly seated and not damaged or dirty. Clean it if needed
- 2Switch off the ignition and check the camshaft sensor connector for contact resistance and oxidation
- 3Use a multimeter to check that the wires to the camshaft sensor have no open circuit and no short to ground or voltage
- 4Road-test the car after the work, since the fault can only be set while the engine runs above a certain speed
- 5If the fault remains, have a workshop with diagnostic equipment check the camshaft sensor and the control module
Objawy, które możesz zauważyć2
- The engine does not start, or cranks without starting
- The malfunction indicator lamp (MIL) is lit
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.