VOLVO
ECM-1111 - Accelerator pedal position sensor. Idling switch faulty signal. Intermittent fault
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
2 modeleS40 (1996–2004), V40 (1996–2004)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The accelerator pedal sensor combines a position sensor with an idling switch. The ECM sets the code when it finds a fault on the position sensor's signal wire, on its supply, or on the idling switch wire. The fault comes and goes, and it may show as a poor response from the accelerator and a raised idle.
Możliwe przyczyny
- Signal wire to the position sensor shorted to supply voltage, shorted to earth, or open, intermittently
- Supply wire to the position sensor shorted to battery voltage or earth
- Defective accelerator pedal position sensor
- Defective engine control module (ECM)
- Open circuit in the earth wire to the idling switch
Co możesz zrobić
- 1If you have a diagnostic tool, read out the fault code status and see whether the fault is still present
- 2With the ignition off, check the accelerator pedal connector and wiring for loose contacts, oxidation and chafing
- 3With the pedal released the idling switch should be closed, and it should open when the pedal is pressed; check this with a multimeter
- 4Check the earth wire to the accelerator pedal sensor for an intermittent open circuit, since that can cause the fault
- 5If the fault remains, have a workshop check the accelerator pedal sensor and wiring with diagnostic equipment
Objawy, które możesz zauważyć3
- Malfunction indicator lamp lit
- No response from the accelerator pedal
- High idling speed
Na co może wpływać usterka1
- Idle speed is raised
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.