VOLVO
ECM-1221 - Electronic throttle module signal. Faulty signal
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
2 modeleS40 (1996–2004), V40 (1996–2004)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The engine control module compares the actual throttle angle with the angle it has requested. If they do not agree, the code is set. The fault can lie in the relay, in the wiring to the throttle module control unit or servo, or in the throttle module itself.
Możliwe przyczyny
- Contact resistance in the connections
- Faulty relay for the throttle module
- Open circuit in the signal wire to the relay control unit, or a short to supply voltage on it
- Open or short circuit to ground or supply voltage on the throttle motor signal wires
- Open circuit in the power supply or ground wire to the throttle module control unit
- Faulty throttle module
Co możesz zrobić
- 1Read the codes and deal first with those for the throttle system, since they may share the same cause
- 2Check the connectors to the throttle module and the throttle position sensor for contact resistance and oxidation
- 3Have a workshop measure the resistance of the throttle motor and replace the motor if needed
- 4Checking the relay means moving relays and activating the fuel pump, so have a workshop with diagnostic equipment do it
- 5If nothing is found, an intermittent fault or a defective throttle module is likely, and a workshop should check it
Objawy, które możesz zauważyć4
- Malfunction indicator lamp on
- The car performs worse
- Fuel consumption is high
- Cruise control does not work at all
Na co może wpływać usterka2
- Engine output is limited
- Cruise control is switched off
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.