VOLVO
ECM-2303 - Ignition coil 2. Signal too low
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
3 modeleC30 (2007–2013), S40 (2004–2013), V50 (2004–2013)
Co oznacza ten kod błędu?
The engine control module (ECM) keeps watch over the ignition circuitry. The code is set when the signal from ignition coil 2 is too low. That coil supplies cylinders 2 and 3. The usual cause is a primary wire shorted to ground or a damaged coil.
Możliwe przyczyny
- Primary wire shorted to ground
- Damaged ignition coil
Co możesz zrobić
- 1Read the code, note it and clear it. Then road test to see whether it comes back
- 2Make sure the connector to ignition coil 2 is firmly seated and check the contacts for corrosion
- 3Inspect the primary wire to ignition coil 2 for chafing or breaks, especially where it rests against edges in the engine bay
- 4If you have a diagnostic tool: read the ignition coil 2 signal in live data while the engine runs
- 5If the fault remains, have a workshop decide whether the coil needs replacing
Objawy, które możesz zauważyć1
- Malfunction indicator lamp (MIL) lit
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.