VOLVO
ECM-2453 - Pressure sensor, particle filter. Faulty signal
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
4 modeleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Pokaż modele wg rocznika i silnika (6)
- Volvo C30 (2007–2013)2007–2010Tylko silnik: D4204T
- Volvo C70 (2006–2013)2008–2010Tylko silnik: D4204T
- Volvo S40 (2004–2013)2005–2006Tylko silnik: D4204T, D4204T2
- Volvo S40 (2004–2013)2007–2010Tylko silnik: D4204T
- Volvo V50 (2004–2013)2005–2006Tylko silnik: D4204T, D4204T2
- Volvo V50 (2004–2013)2007–2010Tylko silnik: D4204T
Co oznacza ten kod błędu?
The ECM compares pressure readings from each side of the particle filter and checks that the pressure sensor signal follows a calculated value. The code is stored when the signal is uneven or unreasonable. The fault concerns the sensor signal and can be caused by a poor connection or a damaged pressure sensor.
Możliwe przyczyny
- Contact resistance or oxidation at the connections
- Damaged pressure sensor for the particle filter
Co możesz zrobić
- 1Read and note the code, clear it and road test to see whether it returns
- 2Check the connector to the particle filter pressure sensor for oxidation and loose connections
- 3Follow the wiring harness from the pressure sensor and look for chafing and pinch damage
- 4With a diagnostic tool, check the pressure sensor value in live data with the engine off. It should be low, and a value that jumps around points to the sensor
- 5If the connector and cable are intact, have a workshop with diagnostic equipment check and, if needed, replace the pressure sensor
Objawy, które możesz zauważyć2
- The check engine light comes on
- Poor performance, the car lacks power
Na co może wpływać usterka1
- Engine output and speed may be limited
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.