Przejdź do treści
    OBD Tuning
    WYŚLIJ DO NAS
    WYŚLIJ DO NAS
    Strona główna
    Kody błędów
    VOLVO
    ECM-2920
    VOLVO

    ECM-2920 - Heated oxygen sensor (HO2S) preheating, bank 2. Faulty signal. Intermittent fault

    Układ

    Sterownik silnika (ECM)

    Modele Volvo, których dotyczy ten kod błędu

    Dotyczy następujących modeli:

    1 model

    S80 (1999–2006)

    Pokaż modele wg rocznika i silnika (1)
    • Volvo S80 (1999–2006)2002Tylko silnik: B6294S2, B6294T

    Co oznacza ten kod błędu?

    The resistance in the heating circuit of the front oxygen sensor on bank 2 has been out of range, either too high or too low, for a set time, so the code is set. The fault is intermittent, meaning it has occurred at some point but may not be present now. Possible causes are poor contact, an interruption in the supply from the system relay or a defective sensor.

    Możliwe przyczyny

    • Contact resistance and oxidation in the connections
    • Interruption in the supply from the system relay
    • Defective oxygen sensor
    • Break in the signal cable

    Co możesz zrobić

    1. 1Read the code, clear it and drive for a while to see whether it returns
    2. 2Check the bank 2 sensor connector for oxidation and contact resistance, and make sure it is secure
    3. 3With the car switched off, use a multimeter to check that the signal wire is not broken
    4. 4With the ignition on, check that the supply from the system relay reaches the sensor
    5. 5If you have a diagnostic tool: after the engine has run a while, read the front sensor fault status. If the fault is no longer active, it was probably intermittent

    Objawy, które możesz zauważyć1

    • Malfunction indicator lamp (MIL) lights

    Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.

    OBD Tuning

    Wiodące centrum ekspertów Szwecji w elektronice motoryzacyjnej. Oferujemy profesjonalną optymalizację silnika, naprawę sterowników i diagnostykę z gwarancją 12 miesięcy.

    Usługi

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    Baza danych & Diagnostyka

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    Producenci ECU

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Firma

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    Odwiedź nas

    Gjuterigatan 29, Karlstad

    Zadzwoń do nas

    054-830 480

    Napisz do nas

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Wszelkie prawa zastrzeżone.