VOLVO
ECM-922D - Electronic throttle unit, potentiometer 2. Signal too low
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
9 modeliC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2001–2009), S80 (1999–2006), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Pokaż modele wg rocznika i silnika (23)
- Volvo C30 (2007–2013)2007Tylko silnik: B5254T3
- Volvo C30 (2007–2013)2008–2013Tylko silnik: B5254T7
- Volvo C70 (2006–2013)2006–2007Tylko silnik: B5254T3
- Volvo C70 (2006–2013)2008–2013Tylko silnik: B5254T7
- Volvo S40 (2004–2013)2005–2007Tylko silnik: B5254T3
- Volvo S40 (2004–2013)2008Tylko silnik: B5254T3, B5254T7
- Volvo S40 (2004–2013)2009–2012Tylko silnik: B5254T7
- Volvo S60 (2001–2009)2005–2006Tylko silnik: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2007Tylko silnik: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2008–2009Tylko silnik: B5204T5, B5244T5, B5254T2
- Volvo S80 (1999–2006)2005–2006Tylko silnik: B5204T5, B5244T4, B5254T2, B6294S2, B6294T
- Volvo V50 (2004–2013)2005–2007Tylko silnik: B5254T3
- Volvo V50 (2004–2013)2008–2012Tylko silnik: B5254T7
- Volvo V70 (2000–2008)2005Tylko silnik: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2006–2007Tylko silnik: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2008Tylko silnik: B5254T2
- Volvo V70 XC / XC70 (2001–2007)2005Wszystkie silniki oprócz: D5244T
- Volvo V70 XC / XC70 (2001–2007)2006Tylko silnik: B5244T4, B5254T2
- Volvo V70 XC / XC70 (2001–2007)2007Tylko silnik: B5254T2
- Volvo XC90 (2003–)2005–2006Tylko silnik: B5254T2, B6294T
- Volvo XC90 (2003–)2007–2012Tylko silnik: B5254T2
- Volvo XC90 (2003–)2013–2014Tylko silnik: B5254T9
- Volvo XC90 (2003–)2015
Co oznacza ten kod błędu?
The engine control module (ECM) monitors the signal from potentiometer 2, the second throttle position sensor, which is too low, and sets the code. The cause can be poor contact, a signal cable shorted to ground or open, or a supply to the potentiometers that is open or shorted to ground.
Możliwe przyczyny
- Contact resistance or oxidation between the ECM and the throttle unit
- Signal cable short-circuited to ground or open circuit
- Open circuit or short-circuit to ground in the supply to potentiometers 1 and 2
- Damaged throttle unit
Co możesz zrobić
- 1Check the connectors between the ECM and the throttle unit for contact resistance and oxidation
- 2Use a multimeter to check that the signal cable is not short-circuited to ground and has no open circuit
- 3Use a multimeter to check that the supply to the potentiometers has no open circuit and is not short-circuited to ground
- 4If the fault remains after these checks, the throttle unit may need replacing by a workshop, which also carries out the adaptation
Objawy, które możesz zauważyć1
- The car's performance is reduced
Na co może wpływać usterka2
- Potentiometer 1 takes over the throttle angle calculation
- If potentiometer 1 also has a fault, its code is set too, and if both are stored the supply to the throttle motor is switched off
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.