VOLVO
ECM-9280 - Throttle unit. Faulty signal
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
9 modeliC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2001–2009), S80 (1999–2006), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Pokaż modele wg rocznika i silnika (23)
- Volvo C30 (2007–2013)2007Tylko silnik: B5254T3
- Volvo C30 (2007–2013)2008–2013Tylko silnik: B5254T7
- Volvo C70 (2006–2013)2006–2007Tylko silnik: B5254T3
- Volvo C70 (2006–2013)2008–2013Tylko silnik: B5254T7
- Volvo S40 (2004–2013)2005–2007Tylko silnik: B5254T3
- Volvo S40 (2004–2013)2008Tylko silnik: B5254T3, B5254T7
- Volvo S40 (2004–2013)2009–2012Tylko silnik: B5254T7
- Volvo S60 (2001–2009)2005–2006Tylko silnik: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2007Tylko silnik: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2008–2009Tylko silnik: B5204T5, B5244T5, B5254T2
- Volvo S80 (1999–2006)2005–2006Tylko silnik: B5204T5, B5244T4, B5254T2, B6294S2, B6294T
- Volvo V50 (2004–2013)2005–2007Tylko silnik: B5254T3
- Volvo V50 (2004–2013)2008–2012Tylko silnik: B5254T7
- Volvo V70 (2000–2008)2005Tylko silnik: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2006–2007Tylko silnik: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2008Tylko silnik: B5254T2
- Volvo V70 XC / XC70 (2001–2007)2005Wszystkie silniki oprócz: D5244T
- Volvo V70 XC / XC70 (2001–2007)2006Tylko silnik: B5244T4, B5254T2
- Volvo V70 XC / XC70 (2001–2007)2007Tylko silnik: B5254T2
- Volvo XC90 (2003–)2005–2006Tylko silnik: B5254T2, B6294T
- Volvo XC90 (2003–)2007–2012Tylko silnik: B5254T2
- Volvo XC90 (2003–)2013–2014Tylko silnik: B5254T9
- Volvo XC90 (2003–)2015
Co oznacza ten kod błędu?
Although the code is titled faulty signal, it applies to the throttle angle in the fully returned end position. The engine control module (ECM) sets the code when it tries to adapt the throttle unit and this angle is outside the programmed limit.
Możliwe przyczyny
- The throttle sticks or is blocked by oil film or dust
- Contact resistance or oxidation in the connectors between the ECM and the throttle unit
- A damaged throttle unit
Co możesz zrobić
- 1Read the fault codes and deal first with any that relate to the throttle unit, throttle position sensor or ECM
- 2Check that nothing is blocking the throttle and that it is not sticking. Clean as needed
- 3Check that the connectors at the throttle unit and the ECM are secure and free from corrosion
- 4With the ignition off: open the throttle carefully by hand and let go. If it does not return to rest by itself, this points to a damaged throttle unit
- 5If you have a diagnostic tool: check in the parameters that the throttle unit adaptation shows OK. The adaptation itself is carried out by a workshop
- 6If the code remains after this, the throttle unit may need replacing. The new unit must be adapted, which a workshop with diagnostic equipment does
Objawy, które możesz zauważyć2
- Poor driving, the car lacks power
- Uneven or unsteady idle
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.