Przejdź do treści
    OBD Tuning
    WYŚLIJ DO NAS
    WYŚLIJ DO NAS
    Strona główna
    Kody błędów
    VOLVO
    ECM-B10E84B
    VOLVO

    ECM-B10E84B - Secondary Battery Relay "A". System Internal Failures. Over temperature

    Układ

    Sterownik silnika (ECM)

    Modele Volvo, których dotyczy ten kod błędu

    Dotyczy następujących modeli:

    8 modeli

    S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)

    Pokaż modele wg rocznika i silnika (29)
    • Volvo S60 (2011–)2011Tylko silnik: B4164T, B4164T3
    • Volvo S60 (2011–)2012Wszystkie silniki oprócz: B4204T7, B5254T5, B6304T4, D4162T
    • Volvo S60 (2011–)2013–2014Tylko silnik: B4164T, B4164T2, B4164T3, D5204T3, D5204T7, D5244T11, D5244T15
    • Volvo S60 (2011–)2015Tylko silnik: B4164T, B4164T2, B4164T3, D5204T3, D5204T7, D5244T11, D5244T15, D5244T23
    • Volvo S80 (2007–)2011Tylko silnik: B4164T
    • Volvo S80 (2007–)2012Tylko silnik: B4164T, B4164T2, D5204T3, D5244T11, D5244T15
    • Volvo S80 (2007–)2013–2014Tylko silnik: B4164T, B4164T2, D5204T3, D5204T7, D5244T11, D5244T15
    • Volvo S80 (2007–)2015Tylko silnik: B4164T, D5204T3, D5244T15
    • Volvo V40 (2013–)2013Tylko silnik: B4164T, B4164T3, D5204T4, D5204T6
    • Volvo V40 (2013–)2014Tylko silnik: B4164T, B4164T3, B4164T4, D5204T4, D5204T6
    • Volvo V40 (2013–)2015Tylko silnik: B4164T, B4164T3, B4164T4, D5204T6
    • Volvo V40 Cross Country (2013–)2013–2014Tylko silnik: B4164T, D5204T4, D5204T6
    • Volvo V40 Cross Country (2013–)2015Tylko silnik: B4164T, D5204T6
    • Volvo V60 (2011–)2011Tylko silnik: B4164T, B4164T3
    • Volvo V60 (2011–)2012Wszystkie silniki oprócz: B4204T7, B6304T4, D4162T
    • Volvo V60 (2011–)2013Wszystkie silniki oprócz: B4204T7, B5204T8, B5204T9, B6304T4, D4162T, D82PHEV
    • Volvo V60 (2011–)2014Tylko silnik: B4164T, B4164T2, B4164T3, D5204T3, D5204T7, D5244T11, D5244T12, D5244T15, D5244T17
    • Volvo V60 (2011–)2015Tylko silnik: B4164T, B4164T2, B4164T3, D5204T3, D5204T7, D5244T11, D5244T12, D5244T15, D5244T17, D5244T23
    • Volvo V70 (2008–)2011Tylko silnik: B4164T
    • Volvo V70 (2008–)2012Tylko silnik: B4164T, B4164T2, D5204T3, D5244T11, D5244T15
    • Volvo V70 (2008–)2013Wszystkie silniki oprócz: B4204T7, B5204T9, B6304T4, B6324S5, D4162T
    • Volvo V70 (2008–)2014Wszystkie silniki oprócz: B4204T11, B4204T7, B5204T9, B6304T4, B6324S5, D4162T, D4204T5
    • Volvo V70 (2008–)2015Wszystkie silniki oprócz: B4204T11, B5204T9, B6304T4, D4162T, D4204T5
    • Volvo XC60 (2009–)2012Tylko silnik: D5204T3, D5244T11, D5244T15, D5244T17
    • Volvo XC60 (2009–)2013Wszystkie silniki oprócz: B4204T7, B6304T4, B6324S4, B6324S5
    • Volvo XC60 (2009–)2014Tylko silnik: D5204T3, D5204T7, D5244T11, D5244T12, D5244T15, D5244T17
    • Volvo XC60 (2009–)2015Tylko silnik: D5204T3, D5204T7, D5244T11, D5244T12, D5244T15, D5244T17, D5244T23
    • Volvo XC70 (2008–)2012–2013Wszystkie silniki oprócz: B6304T4, B6324S4, B6324S5
    • Volvo XC70 (2008–)2014–2015Tylko silnik: D5204T3, D5244T11, D5244T12, D5244T15, D5244T17

    Co oznacza ten kod błędu?

    The code can be set when the output stage of the engine control module, which drives the secondary battery relay, becomes too hot. The cause may be an overload in the components that the relay controls, or loose connector contacts. While the code is active, automatic start and stop of the engine is switched off.

    Możliwe przyczyny

    • Loose connector contact or oxidation
    • Short circuit in the connections
    • Overload in the connected components
    • Damaged secondary battery relay

    Co możesz zrobić

    1. 1Check that the relevant fuses are intact and that the connectors at the relay are fully seated and free from oxidation
    2. 2With a multimeter, check whether there is a short circuit between the connections to the relay
    3. 3If no fault is found in the connectors and wiring, the fault may be inside the output stage of the engine control module; the module then needs replacing, which a workshop does

    Objawy, które możesz zauważyć2

    • Automatic start/stop of the engine does not work while driving
    • Automatic start/stop of the engine does not work at idle

    Na co może wpływać usterka1

    • The automatic engine start/stop function is switched off

    Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.

    OBD Tuning

    Wiodące centrum ekspertów Szwecji w elektronice motoryzacyjnej. Oferujemy profesjonalną optymalizację silnika, naprawę sterowników i diagnostykę z gwarancją 12 miesięcy.

    Usługi

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    Baza danych & Diagnostyka

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    Producenci ECU

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Firma

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    Odwiedź nas

    Gjuterigatan 29, Karlstad

    Zadzwoń do nas

    054-830 480

    Napisz do nas

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Wszelkie prawa zastrzeżone.