VOLVO
ECM-C001 - Control module, communication fault. Signal missing
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Ten kod błędu ma różne znaczenie w zależności od modelu, rocznika lub silnika. Wybierz znaczenie, które dotyczy Twojego samochodu.
Dotyczy następujących modeli:
4 modeleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Pokaż modele wg rocznika i silnika (6)
- Volvo C30 (2007–2013)2007–2010Tylko silnik: D4204T
- Volvo C70 (2006–2013)2008–2010Tylko silnik: D4204T
- Volvo S40 (2004–2013)2004–2006Tylko silnik: D4204T, D4204T2
- Volvo S40 (2004–2013)2007–2010Tylko silnik: D4204T
- Volvo V50 (2004–2013)2004–2006Tylko silnik: D4204T, D4204T2
- Volvo V50 (2004–2013)2007–2010Tylko silnik: D4204T
Co oznacza ten kod błędu?
The engine control module has received no signal from the other control modules over the CAN network, because a serious disturbance on the high speed side is blocking communication. The fault can appear as a warning message in the display, and it can make the engine control module shut itself off until the power supply is broken.
Możliwe przyczyny
- Contact resistance or oxidation in the connections
- Open circuit in one of the CAN wires
- Short circuit between the CAN wires
- Internal fault in the engine control module
- Internal fault in another control module on the same section of the CAN network
Co możesz zrobić
- 1Start by reading the fault codes from the CEM and the other affected modules. Do not erase the engine control module code until the others have been fixed
- 2Check that the battery is connected and that the fuses are intact
- 3Check the connectors at the engine control module and the CEM for corrosion, loose contacts and damage
- 4Look for chafing or pinched sections along the CAN wires
- 5If a control module stays in limp-home mode after the ignition is switched off and on, disconnect and reconnect the battery negative terminal
- 6If the fault remains, have a workshop measure the resistance and traffic load of the CAN network with diagnostic equipment
Objawy, które możesz zauważyć2
- A warning message or warning symbol appears in the display
- The Check engine warning lamp lights up or behaves abnormally
Na co może wpływać usterka2
- The engine control module switches itself off (bus-off)
- The engine control module stays off until the power supply is broken, and tries to communicate again when it is powered
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.