VOLVO
ECM-E010 - Configuration problem. Software error
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
3 modeleC30 (2007–2013), S40 (2004–2013), V50 (2004–2013)
Pokaż modele wg rocznika i silnika (3)
Co oznacza ten kod błędu?
The engine control module checks its own ID against the setup the CEM broadcasts on CAN. The fault code is set when the IDs do not match, or when communication with the CEM is interrupted. The module then responds only to diagnostic commands and cannot communicate normally on CAN.
Możliwe przyczyny
- Incorrect CAN configuration ID, because the engine control module is not intended for the car, for example a used unit with other software or hardware
- Break in the CAN wiring between the engine control module and the CEM
Co możesz zrobić
- 1If the engine control module has been replaced, check that it is intended for this car. Loading or programming software is workshop work
- 2Read out the fault codes in the CEM first, since fault-tracing starts there
- 3Check that the battery is connected and that the fuses are intact
- 4Look for breaks and chafing on the CAN wires between the engine control module and the CEM
- 5Erase the fault code once the faults are fixed, then road test the car to see whether it returns
- 6If the fault remains, have a workshop check the configuration and download new software if needed
Objawy, które możesz zauważyć5
- General warning lamp lit
- A message appears in the display
- Cruise control is inoperative
- Automatic engine start/stop does not work, both while driving and at idle
- Autostart does not work
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.