VOLVO
ECM-P001700 - Crankshaft Position - Camshaft Position Correlation - Bank 1 Sensor B. General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
2 modeleS80 (2007–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The engine control module checks that the exhaust camshaft is in the correct position relative to the crankshaft and adjusts the adaptation when it is not. The code concerns sensor B, bank 1, which is the exhaust camshaft. It is set when the adaptation changes too much, and it is checked once the engine is warm or being started.
Możliwe przyczyny
- Poor quality engine oil
- Incorrectly set camshafts
- Faulty camshaft control valve
- Damaged VVT unit
- Damaged or worn timing chain
Co możesz zrobić
- 1Read the code and note whether it is active right now or only stored
- 2If you have a diagnostic tool: compare the exhaust camshaft timing angle with the target value in live data with the engine running
- 3Check that the engine oil level is correct and that the oil is clean and of the right quality
- 4Have a workshop check the camshaft basic setting and the drive
- 5Have a workshop clean the control valve, or try a new one if the fault remains
- 6If the fault returns: have a workshop check the VVT unit
Objawy, które możesz zauważyć5
- Uneven idle
- Higher emissions
- Engine stalls while driving
- Engine misfires
- Check engine lamp lit or behaving abnormally
Na co może wpływać usterka1
- The control module uses a fixed value for the camshaft adaptation
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.