VOLVO
ECM-P001F00 - Intake (A) Cam Profile Control Circuit High (Bank 2). General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
5 modeliS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (10)
- Volvo S80 (2007–)2007–2010Tylko silnik: B6324S
- Volvo S80 (2007–)2011–2015Tylko silnik: B6324S5
- Volvo V70 (2008–)2008–2010Tylko silnik: B6324S
- Volvo V70 (2008–)2011–2014Tylko silnik: B6324S5
- Volvo XC60 (2009–)2010Tylko silnik: B6324S
- Volvo XC60 (2009–)2011–2015Tylko silnik: B6324S5
- Volvo XC70 (2008–)2008–2010Tylko silnik: B6324S
- Volvo XC70 (2008–)2011–2015Tylko silnik: B6324S5
- Volvo XC90 (2003–)2007–2010Tylko silnik: B6324S
- Volvo XC90 (2003–)2011–2014Tylko silnik: B6324S5
Co oznacza ten kod błędu?
The engine control module checks the control signal to the cam profile valves on the intake side, bank 2, and controls the variable cam profiles. The code is set when the control signal is too high, and it is tested with the ignition on. It is a general fault with no more specific description.
Możliwe przyczyny
- Dirty or damaged cam profile solenoid
- Signal wire shorted to supply voltage
Co możesz zrobić
- 1Read the code, clear it and road test the car to see whether it returns
- 2Use a multimeter to check that the signal wire to the bank 2 solenoid is not shorted to supply voltage
- 3Check the connector at the solenoid for loose or corroded parts
- 4Have a workshop clean the cam profile solenoid, since metal casting residue in the oil can make it stick
- 5If you have a diagnostic tool: read the fault status once the diagnosis is complete, where it should show that no fault is found
- 6If the fault returns: have a workshop replace the cam profile solenoid if it still malfunctions after two cleanings
Objawy, które możesz zauważyć5
- Emissions warning lamp lit
- Uneven idle
- Engine is hard to start
- Higher fuel consumption
- Reduced performance
Na co może wpływać usterka1
- The variable cam profile on both banks switches to the low-lift position
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.