VOLVO
ECM-P002626 - Intake Valve Control Solenoid Circuit Range/Performance (Bank 1). General Signal Failures. Signal rate of change below threshold
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
3 modeleS60 (2011–), S80 (2007–), V70 (2008–)
Pokaż modele wg rocznika i silnika (9)
- Volvo S60 (2011–)2011–2012Tylko silnik: B5254T5
- Volvo S80 (2007–)2007–2008Tylko silnik: B5254T6
- Volvo S80 (2007–)2009Tylko silnik: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Tylko silnik: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Tylko silnik: B5254T10
- Volvo V70 (2008–)2008Tylko silnik: B5254T6
- Volvo V70 (2008–)2009Tylko silnik: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Tylko silnik: B5254T10, B5254T11
- Volvo V70 (2008–)2012Tylko silnik: B5254T10
Co oznacza ten kod błędu?
The code concerns the control solenoid for the intake valve on bank 1. The engine control module monitors the intake camshaft position and sets the code when the camshaft is not in the commanded position and the solenoid signal changes too slowly. The code is tested when the engine is running and camshaft control is active.
Możliwe przyczyny
- Low engine oil pressure
- Poor quality engine oil
- Sticking camshaft control valve
- Mechanical fault in the VVT unit
Co możesz zrobić
- 1Read the code, clear it and road test the car to see whether it returns
- 2Check the fuse for the supply voltage to the intake camshaft control valve
- 3Check the engine oil level and quality, especially for contamination
- 4Have a workshop measure the oil pressure, since low pressure can cause the fault
- 5If you have a diagnostic tool: activate camshaft control and check that it responds
- 6If the fault returns: have a workshop clean the control valve, or replace it if cleaning does not help
Objawy, które możesz zauważyć4
- Check engine lamp lit or behaving abnormally
- Engine is hard to start and cranks slowly
- The car lacks power
- Engine hesitates or runs jerkily on acceleration and at steady speed
Na co może wpływać usterka1
- Camshaft control is switched off
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.