VOLVO
ECM-P008100 - Intake valve control circuit (bank 2). General fault information. Type of fault not specified.
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
2 modeleS80 (2007–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The engine control module (ECM) adjusts the intake camshaft position with a changeover valve on bank 2, the rear cylinder row close to the passenger compartment. The fault code is set when the control signal to the valve is missing. This can be an open circuit in the signal or supply wire, or a damaged valve.
Możliwe przyczyny
- Open circuit in the signal wire to the changeover valve
- Open circuit in the voltage supply wire to the changeover valve
- Damaged intake camshaft changeover valve
Co możesz zrobić
- 1Check the fuse for the circuit. If it has blown, use a multimeter to check that the wire is not shorted to ground
- 2Have a workshop measure the valve resistance if the connector is in order
- 3Use a multimeter to check that the signal and supply wires to the valve have no open circuit
- 4Check the valve connector for loose connections and corrosion
- 5If you have a diagnostic tool: read the fault status and activate the valve to see whether it responds
- 6If the fault remains, have a workshop with diagnostic equipment check the control module
Objawy, które możesz zauważyć4
- Check engine lamp (MIL) lights up
- Uneven idle
- Poor performance
- The engine can stall while driving
Na co może wpływać usterka1
- Intake camshaft control is switched off
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.