Przejdź do treści
    OBD Tuning
    WYŚLIJ DO NAS
    WYŚLIJ DO NAS
    Strona główna
    Kody błędów
    VOLVO
    ECM-P008A21
    VOLVO

    ECM-P008A21 - Low Pressure Fuel System Pressure - Too Low. General Signal Failures. Signal too low

    Układ

    Sterownik silnika (ECM)

    Modele Volvo, których dotyczy ten kod błędu

    Dotyczy następujących modeli:

    7 modeli

    S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–)

    Pokaż modele wg rocznika i silnika (20)
    • Volvo S60 (2011–)2011Tylko silnik: B4164T, B4164T3, B4204T6, B4204T7
    • Volvo S60 (2011–)2012–2014Tylko silnik: B4164T, B4164T2, B4164T3, B4204T7
    • Volvo S60 (2011–)2015Tylko silnik: B4164T, B4164T2, B4164T3
    • Volvo S80 (2007–)2010Tylko silnik: B4204T6
    • Volvo S80 (2007–)2011Tylko silnik: B4164T, B4204T6, B4204T7
    • Volvo S80 (2007–)2012–2014Tylko silnik: B4164T, B4164T2, B4204T6, B4204T7
    • Volvo S80 (2007–)2015Tylko silnik: B4164T
    • Volvo V40 (2013–)2013Tylko silnik: B4164T, B4164T3
    • Volvo V40 (2013–)2014–2015Tylko silnik: B4164T, B4164T3, B4164T4
    • Volvo V40 Cross Country (2013–)2013–2015Tylko silnik: B4164T
    • Volvo V60 (2011–)2011Tylko silnik: B4164T, B4164T3, B4204T6, B4204T7
    • Volvo V60 (2011–)2012–2014Tylko silnik: B4164T, B4164T2, B4164T3, B4204T7
    • Volvo V60 (2011–)2015Tylko silnik: B4164T, B4164T2, B4164T3
    • Volvo V70 (2008–)2010Tylko silnik: B4204T6
    • Volvo V70 (2008–)2011Tylko silnik: B4164T, B4204T6, B4204T7
    • Volvo V70 (2008–)2012–2014Tylko silnik: B4164T, B4164T2, B4204T7
    • Volvo V70 (2008–)2015Tylko silnik: B4164T, B4164T2
    • Volvo XC60 (2009–)2010Tylko silnik: B4204T6
    • Volvo XC60 (2009–)2011–2012Tylko silnik: B4204T6, B4204T7
    • Volvo XC60 (2009–)2013–2015Tylko silnik: B4204T7

    Co oznacza ten kod błędu?

    The engine control module (ECM) controls fuel pressure through the fuel pump control module and requests a target pressure. The fault code is set when the pressure reported by the sensor stays too low against the requested pressure for a certain time, while the engine runs. The causes can be faults in connections or the pump circuit, leaks or air in the fuel lines, or a damaged sensor or pump.

    Możliwe przyczyny

    • Contact resistance, oxidation or open circuit in the connections
    • Fuel pump supply wire shorted to ground
    • Open circuit in the voltage supply to the fuel pump
    • Leak in the fuel lines
    • Air in the fuel lines
    • Damaged fuel pressure sensor, fuel pump or fuel pump control module

    Co możesz zrobić

    1. 1Check the fuse for the fuel pump. If it has blown, use a multimeter to check that the wire is not shorted to ground
    2. 2Check the connectors at the fuel pump and the fuel pressure sensor for contact resistance and oxidation
    3. 3Look for leaks in the fuel lines
    4. 4If you have a diagnostic tool: read the fuel pressure in live data with the engine running and see whether it stays at a lower level than the requested pressure
    5. 5Have a workshop measure the fuel pressure with a gauge and check the fuel pressure sensor, the fuel pump and its control module

    Objawy, które możesz zauważyć4

    • Check engine lamp (MIL) lights up
    • Poor performance and lack of power, especially when pulling away
    • The engine can stall while driving
    • The engine may hesitate, surge or run jerkily while driving

    Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.

    OBD Tuning

    Wiodące centrum ekspertów Szwecji w elektronice motoryzacyjnej. Oferujemy profesjonalną optymalizację silnika, naprawę sterowników i diagnostykę z gwarancją 12 miesięcy.

    Usługi

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    Baza danych & Diagnostyka

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    Producenci ECU

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Firma

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    Odwiedź nas

    Gjuterigatan 29, Karlstad

    Zadzwoń do nas

    054-830 480

    Napisz do nas

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Wszelkie prawa zastrzeżone.