VOLVO
ECM-P008B00 - Low Pressure Fuel System Pressure - Too High. General Electrical Failures. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
8 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (8)
- Volvo S60 (2011–)2014–2015Tylko silnik: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9, D4204T5
- Volvo S80 (2007–)2014–2015Tylko silnik: B4204T11, B4204T12, B4204T15, D4204T5
- Volvo V40 (2013–)2015Tylko silnik: B4204T11, D4204T14
- Volvo V40 Cross Country (2013–)2015Tylko silnik: B4204T11, D4204T14
- Volvo V60 (2011–)2014–2015Tylko silnik: B4204T11, B4204T12, B4204T15, B4204T9, D4204T5
- Volvo V70 (2008–)2014–2015Tylko silnik: B4204T11, D4204T5
- Volvo XC60 (2009–)2014–2015Tylko silnik: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9, D4204T5
- Volvo XC70 (2008–)2014–2015Tylko silnik: B4204T11, D4204T5
Co oznacza ten kod błędu?
The engine control module (ECM) compares the fuel pressure on the low-pressure side with the highest allowed pressure while the engine is running. The fault code is set when the pressure is too far above the target value for a certain time. The causes can be air in the fuel system, leaks in the fuel lines, or a fault in the sensor, pump or pump control module.
Możliwe przyczyny
- Clogged high-pressure pump
- Clogged check valve in the inlet pipe
- Air in the fuel system
- Leak in the fuel lines
- Damaged fuel pressure sensor
- Damaged fuel pump or fuel pump control module
Co możesz zrobić
- 1Check the fuel lines for leaks
- 2Check the connectors at the fuel pressure sensor and the fuel pump for oxidation and loose contacts
- 3If you have a diagnostic tool: read the fuel pressure in live data with the engine running and see whether it is higher than the control module requests
- 4Have a workshop check the fuel pressure sensor with a gauge, and the fuel pump and its control module
- 5Have a workshop check the check valve in the inlet pipe and the high-pressure pump if the fault remains
Objawy, które możesz zauważyć5
- The engine does not start, it only cranks
- The engine can stall at idle or while driving
- Uneven idle
- Poor performance and lack of power, especially when pulling away from a standstill
- Check engine lamp (MIL) lights up
Na co może wpływać usterka1
- The fuel pump is controlled using a calculated value instead of the measured one
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.