VOLVO
ECM-P010122 - Mass or Volume Air Flow Circuit Range/Performance. General Signal Failures. Signal too high
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
3 modeleS60 (2011–), S80 (2007–), V70 (2008–)
Pokaż modele wg rocznika i silnika (9)
- Volvo S60 (2011–)2011–2012Tylko silnik: B5254T5
- Volvo S80 (2007–)2007–2008Tylko silnik: B5254T6
- Volvo S80 (2007–)2009Tylko silnik: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Tylko silnik: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Tylko silnik: B5254T10
- Volvo V70 (2008–)2008Tylko silnik: B5254T6
- Volvo V70 (2008–)2009Tylko silnik: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Tylko silnik: B5254T10, B5254T11
- Volvo V70 (2008–)2012Tylko silnik: B5254T10
Co oznacza ten kod błędu?
The ECM estimates the air mass it expects from a range of parameters and checks that estimate against the reading the mass air flow sensor gives. The code is stored once the air mass correction factor has become too low and the lambda adaptation has drifted above or below a fixed figure. The fault is mainly noticed as a lit eco indicator and reduced performance.
Możliwe przyczyny
- Contact resistance and oxidation in the mass air flow sensor connector terminals
- Air leak in the intake system
- Blocked intake system
- Damaged mass air flow sensor
Co możesz zrobić
- 1Read and note the code, clear it and road test to see whether it returns
- 2Check that the mass air flow sensor connector is fully engaged and free from oxidation
- 3Look for leaks in the hoses and joints between the mass air flow sensor and the throttle body, especially cracks and loose clamps
- 4Look for blockages in the intake system, for example deposits on the throttle body
- 5If the fault remains after the intake system is checked, have a workshop check the mass air flow sensor
Objawy, które możesz zauważyć2
- Eco indicator lamp lit
- The car runs poorly
Na co może wpływać usterka3
- Calculated boost pressure and calculated air mass are used
- Rear lambda sensor control is switched off
- Misfire diagnosis is switched off
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.