Przejdź do treści
    OBD Tuning
    WYŚLIJ DO NAS
    WYŚLIJ DO NAS
    Strona główna
    Kody błędów
    VOLVO
    ECM-P013500
    VOLVO

    ECM-P013500 - O2 Heater Circuit (Bank 1, Sensor 1). General Failure Information. No sub type information

    Układ

    Sterownik silnika (ECM)

    Modele Volvo, których dotyczy ten kod błędu

    Dotyczy następujących modeli:

    3 modele

    S60 (2011–), S80 (2007–), V70 (2008–)

    Pokaż modele wg rocznika i silnika (10)
    • Volvo S60 (2011–)2011–2012Tylko silnik: B5254T5
    • Volvo S80 (2007–)2007Tylko silnik: B5254T6
    • Volvo S80 (2007–)2008Tylko silnik: B4204S3, B4204S4, B5254T6
    • Volvo S80 (2007–)2009Tylko silnik: B4204S3, B4204S4, B5254T6, B5254T8
    • Volvo S80 (2007–)2010–2011Tylko silnik: B4204S3, B4204S4, B5254T10, B5254T11, B5254T8
    • Volvo S80 (2007–)2012Tylko silnik: B5254T10
    • Volvo V70 (2008–)2008Tylko silnik: B4204S3, B4204S4, B5254T6
    • Volvo V70 (2008–)2009Tylko silnik: B4204S3, B4204S4, B5254T6, B5254T8
    • Volvo V70 (2008–)2010–2011Tylko silnik: B4204S3, B4204S4, B5254T10, B5254T11
    • Volvo V70 (2008–)2012Tylko silnik: B5254T10

    Co oznacza ten kod błędu?

    The engine control module (ECM) monitors the heater in the front oxygen sensor in bank 1. The heater brings the sensor up to temperature quickly enough to give a usable signal. The ECM sets the code when the resistance of the heater circuit is too high, which gives a low temperature, or when the voltage in the circuit differs from what is expected with the heater off or on.

    Możliwe przyczyny

    • Contact resistance and oxidation in the connections
    • Open circuit in the heater wire to the sensor, or the wire shorted to ground
    • Damaged front oxygen sensor

    Co możesz zrobić

    1. 1Read the code, clear it and road test the car to see whether it comes back
    2. 2Check that the connector is engaged and clean; measure from the wire side where possible, and do not use rust solvent spray or grease
    3. 3Use a multimeter to check that the heater wire has no open circuit and is not shorted to ground (the body)
    4. 4If the connectors and wiring are intact, replace the front oxygen sensor

    Objawy, które możesz zauważyć1

    • Check engine light (MIL) on

    Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.

    OBD Tuning

    Wiodące centrum ekspertów Szwecji w elektronice motoryzacyjnej. Oferujemy profesjonalną optymalizację silnika, naprawę sterowników i diagnostykę z gwarancją 12 miesięcy.

    Usługi

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    Baza danych & Diagnostyka

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    Producenci ECU

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Firma

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    Odwiedź nas

    Gjuterigatan 29, Karlstad

    Zadzwoń do nas

    054-830 480

    Napisz do nas

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Wszelkie prawa zastrzeżone.