VOLVO
ECM-P013616 - O2 Sensor Circuit (Bank 1 Sensor 2). General Electrical Failures. Circuit voltage below threshold
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
8 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (28)
- Volvo S60 (2011–)2011Tylko silnik: B4164T, B4164T3, B4204T6, B4204T7
- Volvo S60 (2011–)2012–2013Tylko silnik: B4164T, B4164T2, B4164T3, B4204T7
- Volvo S60 (2011–)2014Tylko silnik: B4164T, B4164T2, B4164T3, B4204T7, D4204T5
- Volvo S60 (2011–)2015Tylko silnik: B4164T, B4164T2, B4164T3, D4204T5
- Volvo S80 (2007–)2010Tylko silnik: B4204T6
- Volvo S80 (2007–)2011Tylko silnik: B4164T, B4204T6, B4204T7
- Volvo S80 (2007–)2012–2013Tylko silnik: B4164T, B4164T2, B4204T6, B4204T7
- Volvo S80 (2007–)2014Tylko silnik: B4164T, B4164T2, B4204T6, B4204T7, D4204T5
- Volvo S80 (2007–)2015Tylko silnik: B4164T, D4204T5
- Volvo V40 (2013–)2013Tylko silnik: B4164T, B4164T3
- Volvo V40 (2013–)2014Tylko silnik: B4164T, B4164T3, B4164T4
- Volvo V40 (2013–)2015Tylko silnik: B4164T, B4164T3, B4164T4, D4204T14
- Volvo V40 Cross Country (2013–)2013–2014Tylko silnik: B4164T
- Volvo V40 Cross Country (2013–)2015Tylko silnik: B4164T, D4204T14
- Volvo V60 (2011–)2011Tylko silnik: B4164T, B4164T3, B4204T6, B4204T7
- Volvo V60 (2011–)2012–2013Tylko silnik: B4164T, B4164T2, B4164T3, B4204T7
- Volvo V60 (2011–)2014Tylko silnik: B4164T, B4164T2, B4164T3, B4204T7, D4204T5
- Volvo V60 (2011–)2015Tylko silnik: B4164T, B4164T2, B4164T3, D4204T5
- Volvo V70 (2008–)2010Tylko silnik: B4204T6
- Volvo V70 (2008–)2011Tylko silnik: B4164T, B4204T6, B4204T7
- Volvo V70 (2008–)2012–2013Tylko silnik: B4164T, B4164T2, B4204T7
- Volvo V70 (2008–)2014Tylko silnik: B4164T, B4164T2, B4204T7, D4204T5
- Volvo V70 (2008–)2015Tylko silnik: B4164T, B4164T2, D4204T5
- Volvo XC60 (2009–)2010Tylko silnik: B4204T6
- Volvo XC60 (2009–)2011–2012Tylko silnik: B4204T6, B4204T7
- Volvo XC60 (2009–)2013Tylko silnik: B4204T7
- Volvo XC60 (2009–)2014–2015Tylko silnik: B4204T7, D4204T5
- Volvo XC70 (2008–)2014–2015Tylko silnik: D4204T5
Co oznacza ten kod błędu?
Although the code is named for a low voltage, it concerns the signal from the oxygen sensor in bank 1, sensor 2. The engine control module (ECM) monitors the signal and sets the code when it deviates from its permitted range, or when the sensor's pre-heating voltage disturbs the signal.
Możliwe przyczyny
- Signal wire shorted to the pre-heating circuit
- Ground wire shorted to the pre-heating circuit
- Wire shorted to ground
- Damaged oxygen sensor
Co możesz zrobić
- 1Read the code, clear it and road test the car to see whether it comes back
- 2Check the connector to the oxygen sensor for contact resistance and oxidation; do not use rust solvent spray or grease
- 3Use a multimeter to check that the signal and ground wires to the sensor are not shorted to each other or to ground
- 4If the connector and wires are intact, replace the oxygen sensor
Objawy, które możesz zauważyć1
- Check engine light (MIL) on
Na co może wpływać usterka3
- Control with the oxygen sensor is switched off
- Catalytic converter diagnostics are disabled
- The engine control module uses a calculated value instead of the sensor signal
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.