VOLVO
ECM-P025113 - Injection Pump Fuel Metering Control A. General Electrical Failures. Circuit open
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
8 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (28)
- Volvo S60 (2011–)2011Tylko silnik: B4164T, B4164T3, B4204T6, B4204T7
- Volvo S60 (2011–)2012–2013Tylko silnik: B4164T, B4164T2, B4164T3, B4204T7
- Volvo S60 (2011–)2014Tylko silnik: B4164T, B4164T2, B4164T3, B4204T7, D4204T5
- Volvo S60 (2011–)2015Tylko silnik: B4164T, B4164T2, B4164T3, D4204T5
- Volvo S80 (2007–)2010Tylko silnik: B4204T6, D4164T
- Volvo S80 (2007–)2011Tylko silnik: B4164T, B4204T6, B4204T7, D4164T
- Volvo S80 (2007–)2012–2013Tylko silnik: B4164T, B4164T2, B4204T6, B4204T7
- Volvo S80 (2007–)2014Tylko silnik: B4164T, B4164T2, B4204T6, B4204T7, D4204T5
- Volvo S80 (2007–)2015Tylko silnik: B4164T, D4204T5
- Volvo V40 (2013–)2013Tylko silnik: B4164T, B4164T3
- Volvo V40 (2013–)2014Tylko silnik: B4164T, B4164T3, B4164T4
- Volvo V40 (2013–)2015Tylko silnik: B4164T, B4164T3, B4164T4, D4204T14
- Volvo V40 Cross Country (2013–)2013–2014Tylko silnik: B4164T
- Volvo V40 Cross Country (2013–)2015Tylko silnik: B4164T, D4204T14
- Volvo V60 (2011–)2011Tylko silnik: B4164T, B4164T3, B4204T6, B4204T7
- Volvo V60 (2011–)2012–2013Tylko silnik: B4164T, B4164T2, B4164T3, B4204T7
- Volvo V60 (2011–)2014Tylko silnik: B4164T, B4164T2, B4164T3, B4204T7, D4204T5
- Volvo V60 (2011–)2015Tylko silnik: B4164T, B4164T2, B4164T3, D4204T5
- Volvo V70 (2008–)2010Tylko silnik: B4204T6, D4164T
- Volvo V70 (2008–)2011Tylko silnik: B4164T, B4204T6, B4204T7, D4164T
- Volvo V70 (2008–)2012–2013Tylko silnik: B4164T, B4164T2, B4204T7
- Volvo V70 (2008–)2014Tylko silnik: B4164T, B4164T2, B4204T7, D4204T5
- Volvo V70 (2008–)2015Tylko silnik: B4164T, B4164T2, D4204T5
- Volvo XC60 (2009–)2010Tylko silnik: B4204T6
- Volvo XC60 (2009–)2011–2012Tylko silnik: B4204T6, B4204T7
- Volvo XC60 (2009–)2013Tylko silnik: B4204T7
- Volvo XC60 (2009–)2014–2015Tylko silnik: B4204T7, D4204T5
- Volvo XC70 (2008–)2014–2015Tylko silnik: D4204T5
Co oznacza ten kod błędu?
The ECM watches the fuel pressure control valve and the high-pressure side of the fuel system. The fault is set when there is a break in the valve's signal wire, or when the output stage of the control module finds the drive to the fuel flow valve out of range. It is an electrical fault with an open circuit.
Możliwe przyczyny
- Loose contact, contact resistance or oxidation in the connector
- Open circuit in the supply to the fuel pressure control valve
- Open circuit in the signal wire to the fuel pressure control valve
- Damaged fuel pump
- Fuel flow control valve is damaged
- Fault inside the engine control module (ECM)
Co możesz zrobić
- 1Read the code, clear it and road test to see whether it returns
- 2Check that the fuel level in the tank is not low, and top up if it is
- 3Check that the fuses are intact. Fuse locations are shown in the owner's manual
- 4Look at the fuel flow control valve connector for contact resistance, oxidation and loose connections
- 5Use a multimeter to check that the wires to the fuel flow control valve are not broken
- 6If the fault remains, have a workshop check the fuel pump and the fuel flow control valve with diagnostic equipment
Objawy, które możesz zauważyć4
- The engine will not start or stalls
- Rough idle
- The car hesitates, surges or runs jerkily
- The check engine lamp comes on or behaves abnormally
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.