VOLVO
ECM-P034192 - Camshaft Position Sensor "A" Circuit Range/Performance (Bank 1 or single sensor). Component Failures. Performance or incorrect operation
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
8 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (8)
- Volvo S60 (2011–)2014–2015Tylko silnik: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9, D4204T5
- Volvo S80 (2007–)2014–2015Tylko silnik: B4204T11, B4204T12, B4204T15, D4204T5
- Volvo V40 (2013–)2015Tylko silnik: B4204T11, D4204T14
- Volvo V40 Cross Country (2013–)2015Tylko silnik: B4204T11, D4204T14
- Volvo V60 (2011–)2014–2015Tylko silnik: B4204T11, B4204T12, B4204T15, B4204T9, D4204T5
- Volvo V70 (2008–)2014–2015Tylko silnik: B4204T11, D4204T5
- Volvo XC60 (2009–)2014–2015Tylko silnik: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9, D4204T5
- Volvo XC70 (2008–)2014–2015Tylko silnik: B4204T11, D4204T5
Co oznacza ten kod błędu?
The fault is stored when the engine control module, during start-up, cannot read the gaps between the camshaft teeth that should be present in one camshaft revolution. The fault concerns the range and performance of the camshaft sensor, and the code does not say which type of fault it is.
Możliwe przyczyny
- Wiring or connector fault that comes and goes
- Camshaft sensor fitted incorrectly
- Damaged camshaft sensor
Co możesz zrobić
- 1If you have a diagnostic tool, start the engine and read the fault status. 'Fault found' means the fault is permanent.
- 2Check that the fuses are intact.
- 3With the ignition off, check that the camshaft sensor is correctly fitted and that its connector is clean and secure.
- 4Check that the wiring to the camshaft sensor has no chafing, pinched areas or loose clips.
- 5If your diagnostic tool shows it, read the camshaft sensor position or speed in live data when the engine starts.
- 6If the fault returns, have a workshop check the camshaft sensor and its wiring.
Objawy, które możesz zauważyć5
- Check engine light is on or behaves abnormally
- Automatic engine start/stop does not work
- Car lacks power
- Car hesitates or jerks while driving, for example during acceleration or when slowing down
- Car hesitates or jerks at steady speed
Na co może wpływać usterka1
- The ECM uses the crankshaft sensor signal instead
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.