VOLVO
ECM-P035611 - Ignition Coil F Primary/Secondary Circuit. General Electrical Failures. Circuit short to ground
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
7 modeliS60 (2011–), S80 (2007–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (10)
- Volvo S60 (2011–)2011–2014Tylko silnik: B6304T4
- Volvo S60 (2011–)2015Tylko silnik: B6304T3, B6304T4, B6304T5
- Volvo S80 (2007–)2011–2015Tylko silnik: B6304T4, B6324S4, B6324S5
- Volvo V60 (2011–)2011–2014Tylko silnik: B6304T4
- Volvo V60 (2011–)2015Tylko silnik: B6304T3, B6304T4, B6304T5
- Volvo V70 (2008–)2011–2014Tylko silnik: B6304T4, B6324S5
- Volvo V70 (2008–)2015Tylko silnik: B6304T4
- Volvo XC60 (2009–)2011–2015Tylko silnik: B6304T4, B6324S4, B6324S5
- Volvo XC70 (2008–)2011–2015Tylko silnik: B6304T4, B6324S4, B6324S5
- Volvo XC90 (2003–)2011–2014Tylko silnik: B6324S5
Co oznacza ten kod błędu?
Ignition coil F has a signal wire that is shorted to ground. The code is stored when the fault persists over two or more driving cycles in a row.
Możliwe przyczyny
- Contact resistance and oxidation in the connections
- Signal wire short circuit to ground
- Damaged ignition coil
Co możesz zrobić
- 1If you have a diagnostic tool, start the engine and read the fault status. 'Fault found' means the fault is permanent.
- 2Check that the fuses are intact.
- 3With the ignition off, check the connector at ignition coil F for contact resistance and oxidation.
- 4Use a multimeter to check that the signal wire to ignition coil F is not shorted to ground (the body).
- 5Look along the signal wire to ignition coil F for chafed or pinched sections.
- 6If the fault returns, have a workshop check ignition coil F and its wire.
Objawy, które możesz zauważyć4
- Car lacks power, especially when pulling away from standstill
- Car hesitates or jerks during acceleration
- Car hesitates or jerks at steady speed
- Automatic engine start/stop does not work
Na co może wpływać usterka1
- Closed loop control of lambda is blocked
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.