VOLVO
ECM-P035700 - Ignition coil G, primary/secondary circuit. General fault information. Type of fault not specified
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
2 modeleS80 (2007–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
This code points to ignition coil G, which is the coil for cylinder 7. The fault is not specified further in the code. The engine control module monitors the signal to the coil through a separate diagnostic line.
Możliwe przyczyny
- Contact resistance and oxidation at the coil connector
- Signal wire short circuit to ground or supply voltage
- Open circuit in the signal wire
- Open circuit in the supply wire
- Diagnostic line short circuit to ground or supply voltage
- Damaged ignition coil
Co możesz zrobić
- 1If you have a diagnostic tool, start the engine and read the fault status. 'Fault found' means the fault is permanent.
- 2Check that the fuses are intact.
- 3With the ignition off, check the connector to the ignition coil for cylinder 7 for contact resistance and oxidation.
- 4Use a multimeter to check that the wires to the ignition coil for cylinder 7 have no open circuit and are not shorted to ground or supply voltage.
- 5Check that the ignition coil is secure and not damaged.
- 6If the fault remains after these checks, have a workshop examine the ignition coil for cylinder 7 and its diagnostic line.
Objawy, które możesz zauważyć1
- Engine misfires
Na co może wpływać usterka1
- Closed loop control of lambda is blocked
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.