VOLVO
ECM-P03A000 - Cylinder 2 Fuel Pressure Sensor Circuit Range/Performance. General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
8 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (8)
- Volvo S60 (2011–)2014–2015Tylko silnik: D4204T5
- Volvo S80 (2007–)2014–2015Tylko silnik: D4204T5
- Volvo V40 (2013–)2015Tylko silnik: D4204T14
- Volvo V40 Cross Country (2013–)2015Tylko silnik: D4204T14
- Volvo V60 (2011–)2014–2015Tylko silnik: D4204T5
- Volvo V70 (2008–)2014–2015Tylko silnik: D4204T5
- Volvo XC60 (2009–)2014–2015Tylko silnik: D4204T5
- Volvo XC70 (2008–)2014–2015Tylko silnik: D4204T5
Co oznacza ten kod błędu?
The engine control module (ECM) compares the fuel pressure measured by the pressure sensors in the injectors. The fault is set when the pressure sensor in the injector for cylinder 2 differs from the readings of the other three sensors. The sensor in that cylinder is therefore the one causing the difference.
Możliwe przyczyny
- Pressure sensor in the injector for cylinder 2 is faulty
Co możesz zrobić
- 1If you have a diagnostic tool, compare the reading from the sensor for cylinder 2 with the other three with the engine at idle
- 2Check that the connector at the injector for cylinder 2 is firmly seated and free from oxidation
- 3Measure with a multimeter that the wire to the injector for cylinder 2 has no open circuit and no contact with ground (the body)
- 4Clear the fault code and road test the car to see whether it comes back
- 5If the fault remains, have a workshop check the pressure sensor in the injector for cylinder 2
Objawy, które możesz zauważyć1
- The Check engine (malfunction indicator) light comes on or behaves abnormally
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.