VOLVO
ECM-P055A2F - Engine Oil Pressure Sensor/Switch "B" Circuit. General Signal Failures. Signal erratic
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
8 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (8)
- Volvo S60 (2011–)2014–2015Tylko silnik: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9, D4204T5
- Volvo S80 (2007–)2014–2015Tylko silnik: B4204T11, B4204T12, B4204T15, D4204T5
- Volvo V40 (2013–)2015Tylko silnik: B4204T11, D4204T14
- Volvo V40 Cross Country (2013–)2015Tylko silnik: B4204T11, D4204T14
- Volvo V60 (2011–)2014–2015Tylko silnik: B4204T11, B4204T12, B4204T15, B4204T9, D4204T5
- Volvo V70 (2008–)2014–2015Tylko silnik: B4204T11, D4204T5
- Volvo XC60 (2009–)2014–2015Tylko silnik: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9, D4204T5
- Volvo XC70 (2008–)2014–2015Tylko silnik: B4204T11, D4204T5
Co oznacza ten kod błędu?
The ECM reads oil pressure through the combined oil pressure and oil temperature sensor. The fault is stored when the module detects a general signal fault from the oil pressure sensor, where the signal is erratic and not steady. The module then uses a fixed oil pressure value instead of the measured one.
Możliwe przyczyny
- Contact resistance or oxidation in the connections
- The combined oil pressure and oil temperature sensor is damaged
Co możesz zrobić
- 1Check that the fuses are intact
- 2Check the connector at the oil pressure sensor for contact resistance and oxidation, and see whether it sits loose
- 3If the connector is clean, use a multimeter to check that the signal wire from the sensor has no open circuit or short to ground
- 4If you have diagnostic equipment: read the oil pressure in live data with the engine running and see whether the value jumps around erratically
- 5If the connector and wiring are sound, have a workshop check the combined sensor and replace it if needed
Objawy, które możesz zauważyć1
- No noticeable symptoms for the driver
Na co może wpływać usterka1
- The control module uses a fixed oil pressure instead of the measured value
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.