VOLVO
ECM-P058185 - Cruise Control Multi-Function Input A Circuit High. Bus Signal / Message Failures. Signal above allowable range
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
4 modeleS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (6)
- Volvo S80 (2007–)2009Tylko silnik: D5244T10
- Volvo S80 (2007–)2010Tylko silnik: D5244T10, D5244T14, D5244T19
- Volvo V70 (2008–)2009Tylko silnik: D5244T10
- Volvo V70 (2008–)2010Tylko silnik: D5244T10, D5244T14, D5244T19
- Volvo XC60 (2009–)2010Tylko silnik: D5244T10, D5244T14, D5244T16
- Volvo XC70 (2008–)2010Tylko silnik: D5244T10, D5244T14, D5244T16
Co oznacza ten kod błędu?
The ECM receives information from the front monitoring module (FSM) over the CAN network. The fault is stored when the signal from the FSM is above what is allowed, and it is tested with the ignition on.
Możliwe przyczyny
- The fault may lie in the front monitoring module (FSM)
- Breaks or interference on the CAN wires
- Contact resistance, oxidation or open circuit in connections
- The ECM is not intended for this car, for example a used module with different software or hardware
Co możesz zrobić
- 1Check that the fuses are intact
- 2If you have diagnostic equipment: read the fault codes in the front monitoring module (FSM) and deal with them first
- 3Check that the connectors on the CAN network and to the FSM are firmly seated and not corroded
- 4Use a multimeter to check that the CAN wires have no open circuit or short to ground or supply voltage
- 5If the fault remains, have a workshop check the CAN network and that the correct engine control module is fitted for this car
Objawy, które możesz zauważyć1
- Cruise control does not engage
Na co może wpływać usterka2
- The cruise control function is switched off
- Cruise control cannot be activated
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.