ECM-P061616
VOLVO
ECM-P061616 - Starter Relay Circuit Low. General Electrical Failures. Circuit voltage below threshold
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
8 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (23)
- Volvo S60 (2011–)2012Tylko silnik: D5204T3, D5244T11, D5244T15
- Volvo S60 (2011–)2013–2014Tylko silnik: D5204T3, D5204T7, D5244T11, D5244T15
- Volvo S60 (2011–)2015Tylko silnik: D5204T3, D5204T7, D5244T11, D5244T15, D5244T23
- Volvo S80 (2007–)2012Tylko silnik: D5204T3, D5244T11, D5244T15
- Volvo S80 (2007–)2013–2014Tylko silnik: D5204T3, D5204T7, D5244T11, D5244T15
- Volvo S80 (2007–)2015Tylko silnik: D5204T3, D5244T15
- Volvo V40 (2013–)2013–2014Tylko silnik: D5204T4, D5204T6
- Volvo V40 (2013–)2015Tylko silnik: D5204T6
- Volvo V40 Cross Country (2013–)2013–2014Tylko silnik: D5204T4, D5204T6
- Volvo V40 Cross Country (2013–)2015Tylko silnik: D5204T6
- Volvo V60 (2011–)2012Tylko silnik: D5204T3, D5244T11, D5244T15
- Volvo V60 (2011–)2013Tylko silnik: D5204T3, D5204T7, D5244T11, D5244T15, D5244T17, D82PHEV
- Volvo V60 (2011–)2014Tylko silnik: D5204T3, D5204T7, D5244T11, D5244T12, D5244T15, D5244T17, D82PHEV
- Volvo V60 (2011–)2015Tylko silnik: D5204T3, D5204T7, D5244T11, D5244T12, D5244T15, D5244T17, D5244T23, D82PHEV, D87PHEV
- Volvo V70 (2008–)2012Tylko silnik: D5204T3, D5244T11, D5244T15
- Volvo V70 (2008–)2013Tylko silnik: D5204T3, D5204T7, D5244T11, D5244T15, D5244T17
- Volvo V70 (2008–)2014–2015Tylko silnik: D5204T3, D5204T7, D5244T11, D5244T12, D5244T15, D5244T17
- Volvo XC60 (2009–)2012Tylko silnik: D5204T3, D5244T11, D5244T15, D5244T17
- Volvo XC60 (2009–)2013Wszystkie silniki oprócz: B4204T7, B6304T4, B6324S4, B6324S5
- Volvo XC60 (2009–)2014Tylko silnik: D5204T3, D5204T7, D5244T11, D5244T12, D5244T15, D5244T17
- Volvo XC60 (2009–)2015Tylko silnik: D5204T3, D5204T7, D5244T11, D5244T12, D5244T15, D5244T17, D5244T23
- Volvo XC70 (2008–)2012–2013Wszystkie silniki oprócz: B6304T4, B6324S4, B6324S5
- Volvo XC70 (2008–)2014–2015Tylko silnik: D5204T3, D5244T11, D5244T12, D5244T15, D5244T17
Co oznacza ten kod błędu?
The engine control module (ECM) has found a fault in the HS line that drives the starter through the start relay, and the voltage on that signal cable is too low. While the fault is active, the engine may start poorly or not at all, and automatic start/stop does not work.
Możliwe przyczyny
- The signal cable to the start relay is short-circuited to ground
Co możesz zrobić
- 1Check that the fuses for the starting system are intact
- 2With the ignition off, check that the connectors at the start relay and the control module are secure and free from corrosion and oxidation
- 3Look for chafed or pinched wiring in the signal cable to the start relay, especially where it may touch the body
- 4Use a multimeter to check that the signal cable to the start relay has no contact with ground (the body)
- 5If you have a diagnostic tool: activate the start relay and listen for it to click, then read the fault code again
- 6If the wiring is intact and the connectors are good but the fault remains: have a workshop check the start relay and the control module
Objawy, które możesz zauważyć3
- The engine does not start, either occasionally or all the time
- Automatic start/stop of the engine does not work while driving
- Automatic start/stop of the engine does not work at idle
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.