VOLVO
ECM-P061E87 - Collision Mitigation By Braking. Bus Signal / Message Failures. Alive / sequence counter incorrect / not updated
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
3 modeleS60 (2011–), S80 (2007–), V70 (2008–)
Pokaż modele wg rocznika i silnika (9)
- Volvo S60 (2011–)2011–2012Tylko silnik: B5254T5
- Volvo S80 (2007–)2007–2008Tylko silnik: B5254T6
- Volvo S80 (2007–)2009Tylko silnik: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Tylko silnik: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Tylko silnik: B5254T10
- Volvo V70 (2008–)2008Tylko silnik: B5254T6
- Volvo V70 (2008–)2009Tylko silnik: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Tylko silnik: B5254T10, B5254T11
- Volvo V70 (2008–)2012Tylko silnik: B5254T10
Co oznacza ten kod błędu?
When there is a collision risk, the engine control module provides brake support using signals from the forward sensing module (FSM). The fault is set when the central electronic module (CEM) does not allow the engine torque to be lowered. The code is set first in the CEM or FSM and then in the engine control module, and it can only be cleared once the root fault has been remedied.
Możliwe przyczyny
- Fault in the forward sensing module (FSM)
- Fault in the central electronic module (CEM)
Co możesz zrobić
- 1There is no separate fault tracing for this code. Start by tracing the control module where the fault was first registered, either the FSM or the CEM
- 2The code can only be cleared once the root fault is remedied and its own code is cleared, so deal with the root fault first
- 3If you have a diagnostic tool: read the fault status in the FSM and the CEM and see which one is active
- 4If the fault remains after the repair: have a workshop handle the fault tracing in the CEM and FSM
Objawy, które możesz zauważyć1
- No noticeable symptoms for the driver
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.