VOLVO
ECM-P062B21 - Internal Control Module Fuel Injector Control Performance. General Signal Failures. Signal too low
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
5 modeliS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (6)
- Volvo S80 (2007–)2007–2009Tylko silnik: D5244T4, D5244T5
- Volvo V70 (2008–)2008–2009Tylko silnik: D5244T4, D5244T5
- Volvo XC60 (2009–)2009Wszystkie silniki oprócz: B6304T2
- Volvo XC70 (2008–)2008Wszystkie silniki oprócz: B6324S
- Volvo XC70 (2008–)2009Tylko silnik: D5244T4, D5244T5
- Volvo XC90 (2003–)2013–2014Tylko silnik: D5244T18, D5244T5
Co oznacza ten kod błędu?
The engine control module monitors the temperature of the exhaust gases and compares it with a calculated value. The code is set when the reading moves too far from the calculated figure, and in this case the signal is too low. This can be due to a damaged temperature sensor or poor contact at the sensor.
Możliwe przyczyny
- Damaged temperature sensor
- Contact resistance or oxidation in the connectors
- The same signal fault as fault code ECM-P062B22 refers to, that is, the signal too high
Co możesz zrobić
- 1Check that the fuses are intact
- 2With the ignition off, check the connector at the temperature sensor for contact resistance and oxidation
- 3If you have a diagnostic tool: read the exhaust temperature in live data when the engine is cold and again when it has warmed up, and see whether it changes smoothly
- 4If the fault remains: have a workshop check the temperature sensor and its wiring
Objawy, które możesz zauważyć1
- No noticeable symptoms for the driver
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.