VOLVO
ECM-P064100 - Sensor Reference Voltage A Circuit/Open. General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
4 modeleS60 (2011–), S80 (2007–), V70 (2008–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (10)
- Volvo S60 (2011–)2011–2012Tylko silnik: B5254T5
- Volvo S80 (2007–)2007–2008Tylko silnik: B5254T6
- Volvo S80 (2007–)2009Tylko silnik: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Tylko silnik: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Tylko silnik: B5254T10
- Volvo V70 (2008–)2008Tylko silnik: B5254T6
- Volvo V70 (2008–)2009Tylko silnik: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Tylko silnik: B5254T10, B5254T11
- Volvo V70 (2008–)2012Tylko silnik: B5254T10
- Volvo XC90 (2003–)2005–2011Tylko silnik: B8444S
Co oznacza ten kod błędu?
The engine control module (ECM) monitors reference voltage A to the sensors. The code is set when the module finds a voltage problem in any internal supply circuit to a component: too high, too low, or no voltage at all. The cause may be in the wiring or a sensor, but it can also be the engine control module itself.
Możliwe przyczyny
- Signal cable for the connected component short-circuited to supply voltage
- Open circuit in the signal cable for the connected component
- Signal cable for the connected component short-circuited to ground
- Supply cable to the sensor short-circuited to ground or supply voltage
- Damaged sensor
- Damaged engine control module (ECM)
Co możesz zrobić
- 1Read the fault codes and first trace any stored codes for sensors supplied from the engine control module
- 2Check that the relevant fuses are intact and that the connectors to the engine control module and the sensors are secure, with no play or oxidation
- 3Use a multimeter to check that the wires from the engine control module to the sensors have no open circuit and are not shorted to ground or supply voltage
- 4If the wiring is intact and the fault remains, have a workshop determine whether a sensor or the engine control module is damaged
Objawy, które możesz zauważyć5
- Uneven idle and increased emissions
- Poor performance
- The engine stops while driving or misfires
- The engine is difficult to start
- The starter motor does not turn, or turns but the engine does not start
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.