VOLVO
ECM-P068600 - ECM/PCM Power Relay Control Circuit Low. General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
3 modeleS60 (2011–), S80 (2007–), V70 (2008–)
Pokaż modele wg rocznika i silnika (9)
- Volvo S60 (2011–)2011–2012Tylko silnik: B5254T5
- Volvo S80 (2007–)2007–2008Tylko silnik: B5254T6
- Volvo S80 (2007–)2009Tylko silnik: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Tylko silnik: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Tylko silnik: B5254T10
- Volvo V70 (2008–)2008Tylko silnik: B5254T6
- Volvo V70 (2008–)2009Tylko silnik: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Tylko silnik: B5254T10, B5254T11
- Volvo V70 (2008–)2012Tylko silnik: B5254T10
Co oznacza ten kod błędu?
The control module checks the system relay and has found a voltage that is too low on the signal wire to the relay while the ignition is on. The code can be caused by a broken wire or a damaged relay. The engine then does not start, and the clicking sound from the relay is absent.
Możliwe przyczyny
- Open circuit in the signal wire
- Damaged system relay
Co możesz zrobić
- 1Read and note the fault code, clear it and try to start the engine to see whether it returns
- 2Check that the battery is charged and that the battery terminals are secure and clean
- 3Check the fuses for the system relay in the owner's manual
- 4Look at the connectors and wiring to the system relay for loose contacts, oxidation and chafing
- 5Use a multimeter to check that the signal wire to the system relay is not open, with the connectors disconnected
- 6If the fault remains, have a workshop check the system relay
Objawy, które możesz zauważyć3
- Engine does not start and does not crank on start attempts
- No clicking sound when you try to start
- The fault may be present all the time, or occur once without a clear pattern
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.