ECM-P080700 - Clutch Position Sensor "A" Circuit Low. General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Ten kod błędu ma różne znaczenie w zależności od modelu, rocznika lub silnika. Wybierz znaczenie, które dotyczy Twojego samochodu.
Dotyczy następujących modeli:
6 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–)
Pokaż modele wg rocznika i silnika (6)
Co oznacza ten kod błędu?
The reading from the clutch pedal position sensor, an analogue sensor relayed by the central electronic module (CEM) over CAN, lies below the permitted range for too long. The engine control module compares the pedal position with other relevant signals, including the pedal switch, to check that it is reasonable. The code is set during driving, and the automatic engine stop-start function is then switched off.
Możliwe przyczyny
- Contact resistance, oxidation or loose connection in the connector
- Damaged signal wire
- Damaged clutch pedal sensor
- Damaged clutch pedal position sensor
Co możesz zrobić
- 1Check that the fuses are intact. The locations are shown in the instruction manual or on the fuse list
- 2Read off and note the fault code, erase it and road-test the car to see whether it returns
- 3Check that the connectors at the clutch pedal sensor and position sensor are firmly seated and free from oxidation
- 4Check that the wiring to the position sensor has no chafing, crush damage or loose clips, especially where the cable moves
- 5Check that the clutch pedal moves freely and does not stick
- 6If you have a diagnostic tool, read live data for the position sensor as the pedal is pressed down and released, and check that the value changes smoothly
Objawy, które możesz zauważyć4
- Starting and auto-start do not work
- Automatic engine stop-start does not work, both at idle and while driving
- The car may hesitate, surge or run jerkily while driving
- The gear change may feel jerky at constant speed
Na co może wpływać usterka1
- The automatic engine stop-start function is switched off
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.