Przejdź do treści
    OBD Tuning
    WYŚLIJ DO NAS
    WYŚLIJ DO NAS
    Strona główna
    Kody błędów
    VOLVO
    ECM-P080800
    VOLVO

    ECM-P080800 - Clutch Position Sensor "A" Circuit High. General Failure Information. No sub type information

    Układ

    Sterownik silnika (ECM)

    Modele Volvo, których dotyczy ten kod błędu

    Ten kod błędu ma różne znaczenie w zależności od modelu, rocznika lub silnika. Wybierz znaczenie, które dotyczy Twojego samochodu.

    Dotyczy następujących modeli:

    6 modeli

    S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–)

    Pokaż modele wg rocznika i silnika (6)
    • Volvo S60 (2011–)2011–2015Tylko silnik: D4162T
    • Volvo S80 (2007–)2012–2015Tylko silnik: D4162T
    • Volvo V40 (2013–)2013–2015Tylko silnik: D4162T
    • Volvo V40 Cross Country (2013–)2013–2015Tylko silnik: D4162T
    • Volvo V60 (2011–)2011–2015Tylko silnik: D4162T
    • Volvo V70 (2008–)2012–2015Tylko silnik: D4162T

    Co oznacza ten kod błędu?

    The engine control module (ECM) keeps watch on the clutch pedal with the position sensor and checks it against the pedal switch. The code is set when the position sensor signal, sent over CAN, lies above the permitted range for longer than allowed.

    Możliwe przyczyny

    • Loose contact, oxidation or contact resistance in the connector
    • Damaged signal wire
    • Damaged clutch pedal sensor
    • Damaged clutch pedal position sensor

    Co możesz zrobić

    1. 1Check that the fuses are intact. The locations are shown in the instruction manual or on the fuse list
    2. 2Try starting, auto-start and automatic stop-start with the buttons and controls to see whether the symptoms can be reproduced
    3. 3Read off and note the fault code, erase it and take the car for a test drive to see whether it returns
    4. 4Check that the connectors at the position sensor and pedal switch are firmly seated and free from oxidation
    5. 5Check that the wiring to the position sensor has no chafing, crush damage or loose clips, especially where the cable moves
    6. 6If you have a diagnostic tool, read live data for the position sensor while pressing and releasing the pedal, and check that the value follows the pedal movement

    Objawy, które możesz zauważyć3

    • Starting and auto-start do not work
    • Automatic engine stop-start does not work, both at idle and while driving
    • The car may hesitate, surge or run jerkily while driving, even at constant speed

    Na co może wpływać usterka1

    • The automatic engine stop-start function is switched off

    Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.

    OBD Tuning

    Wiodące centrum ekspertów Szwecji w elektronice motoryzacyjnej. Oferujemy profesjonalną optymalizację silnika, naprawę sterowników i diagnostykę z gwarancją 12 miesięcy.

    Usługi

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    Baza danych & Diagnostyka

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    Producenci ECU

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Firma

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    Odwiedź nas

    Gjuterigatan 29, Karlstad

    Zadzwoń do nas

    054-830 480

    Napisz do nas

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Wszelkie prawa zastrzeżone.