VOLVO
ECM-P085024 - Park / Neutral Switch Input Circuit. General Signal Failures. Signal stuck high
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
10 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (32)
- Volvo S60 (2011–)2011–2012Tylko silnik: B6304T4
- Volvo S60 (2011–)2013–2014Tylko silnik: B5204T8, B5204T9, B5254T12, B5254T14, B6304T4
- Volvo S60 (2011–)2015Tylko silnik: B5204T8, B5204T9, B5254T12, B5254T14, B6304T3, B6304T4, B6304T5
- Volvo S80 (2007–)2007Tylko silnik: B6324S, B8444S
- Volvo S80 (2007–)2008–2009Tylko silnik: B6304T2, B6324S, B8444S
- Volvo S80 (2007–)2010Tylko silnik: B6304T2, B6324S, B6324S2, B8444S
- Volvo S80 (2007–)2011Tylko silnik: B6304T4, B6324S4, B6324S5, B8444S
- Volvo S80 (2007–)2012, 2015Tylko silnik: B6304T4, B6324S4, B6324S5
- Volvo S80 (2007–)2013–2014Tylko silnik: B5254T12, B5254T14, B6304T4, B6324S4, B6324S5
- Volvo V40 (2013–)2013–2014Tylko silnik: B5204T8, B5204T9, B5254T12, B5254T14
- Volvo V40 (2013–)2015Tylko silnik: B5204T8, B5204T9
- Volvo V40 Cross Country (2013–)2013–2015Tylko silnik: B5204T8, B5204T9, B5254T12, B5254T14
- Volvo V60 (2011–)2011–2012Tylko silnik: B6304T4
- Volvo V60 (2011–)2013Tylko silnik: B5204T8, B5204T9, B6304T4
- Volvo V60 (2011–)2014Tylko silnik: B5204T8, B5204T9, B5254T12, B6304T4
- Volvo V60 (2011–)2015Tylko silnik: B5204T9, B5254T12, B6304T3, B6304T4, B6304T5
- Volvo V60 Cross Country (2015–)2015
- Volvo V70 (2008–)2008–2009Tylko silnik: B6304T2, B6324S
- Volvo V70 (2008–)2010Tylko silnik: B6304T2, B6324S, B6324S2
- Volvo V70 (2008–)2011–2012Tylko silnik: B6304T4, B6324S5
- Volvo V70 (2008–)2013–2014Tylko silnik: B5204T9, B6304T4, B6324S5
- Volvo V70 (2008–)2015Tylko silnik: B5204T9, B6304T4
- Volvo XC60 (2009–)2009Tylko silnik: B6304T2
- Volvo XC60 (2009–)2010Tylko silnik: B6304T2, B6324S, B6324S2
- Volvo XC60 (2009–)2011–2014Tylko silnik: B6304T4, B6324S4, B6324S5
- Volvo XC60 (2009–)2015Tylko silnik: B5204T9, B5254T12, B5254T14, B6304T4, B6324S4, B6324S5
- Volvo XC70 (2008–)2008Tylko silnik: B6324S
- Volvo XC70 (2008–)2009Tylko silnik: B6304T2, B6324S
- Volvo XC70 (2008–)2010Tylko silnik: B6304T2, B6324S, B6324S2
- Volvo XC70 (2008–)2011–2015Tylko silnik: B6304T4, B6324S4, B6324S5
- Volvo XC90 (2003–)2007–2010Tylko silnik: B6324S
- Volvo XC90 (2003–)2011–2014Tylko silnik: B6324S5
Co oznacza ten kod błędu?
The code concerns the gear selector's directly connected wire, which is stuck in a state that does not match the CAN signal from the transmission control module (TCM). The engine control module (ECM) compares the two signals, and the code is set when the CAN signal shows that starting is allowed while the wire shows the opposite. The fault is checked with the ignition in position II.
Możliwe przyczyny
- The root cause is in the transmission control module (TCM)
Co możesz zrobić
- 1Read the fault codes in the transmission control module (TCM) first, as the root cause is there
- 2Check that the fuses are intact. The locations are shown in the instruction manual or on the fuse list
- 3Try starting and auto-start with the buttons and controls to see whether they are affected
- 4If you have a diagnostic tool, check in live data whether the direct selector signal and the CAN signal agree as you move the selector
- 5If the fault returns, have a workshop investigate the gear selector wiring and the transmission control module (TCM)
Objawy, które możesz zauważyć4
- Auto-start is lost or does not work
- Engine starting is delayed or hesitant
- The engine is hard to start and cranks slowly, sometimes or always
- The engine does not start, sometimes or always
Na co może wpływać usterka1
- The ECM uses the signal received over CAN instead
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.