VOLVO
ECM-P086A00 - Neutral Position Sensor "A" Circuit/Open. General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
6 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–)
Pokaż modele wg rocznika i silnika (11)
- Volvo S60 (2011–)2011Tylko silnik: B4164T, B4164T3
- Volvo S60 (2011–)2012–2015Tylko silnik: B4164T, B4164T2, B4164T3
- Volvo S80 (2007–)2011, 2015Tylko silnik: B4164T
- Volvo S80 (2007–)2012–2014Tylko silnik: B4164T, B4164T2
- Volvo V40 (2013–)2013Tylko silnik: B4164T, B4164T3
- Volvo V40 (2013–)2014–2015Tylko silnik: B4164T, B4164T3, B4164T4
- Volvo V40 Cross Country (2013–)2013–2015Tylko silnik: B4164T
- Volvo V60 (2011–)2011Tylko silnik: B4164T, B4164T3
- Volvo V60 (2011–)2012–2015Tylko silnik: B4164T, B4164T2, B4164T3
- Volvo V70 (2008–)2011Tylko silnik: B4164T
- Volvo V70 (2008–)2012–2015Tylko silnik: B4164T, B4164T2
Co oznacza ten kod błędu?
The code concerns neutral position sensor A, which measures how far the input shaft to the gearbox is turned by the gear lever. The sensor has a main sensor and a backup sensor, and the fault is set when the main sensor's reading is too high or too low. Although the code is named open, it applies to a value that is too high or too low.
Możliwe przyczyny
- Signal wire shorted to voltage
- Short to voltage in the connector
- Damaged neutral position sensor
Co możesz zrobić
- 1Check that the fuses are intact. The locations are shown in the instruction manual or on the fuse list
- 2Check that the connector at the neutral position sensor is undamaged, firmly seated and has not been shorted to voltage
- 3Use a multimeter to check that the signal wire to the neutral position sensor has no contact with the battery positive
- 4Where possible, try automatic stop-start with the buttons and controls to see whether it works
- 5If you have a diagnostic tool, check in live data that the neutral position sensor value follows the gear lever position as you move it between the positions
- 6If the fault remains after these checks, have a workshop investigate the neutral position sensor
Objawy, które możesz zauważyć2
- Automatic engine stop-start does not work while driving
- Automatic engine stop-start does not work at idle
Na co może wpływać usterka1
- The automatic engine stop-start function is switched off
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.