Przejdź do treści
    OBD Tuning
    WYŚLIJ DO NAS
    WYŚLIJ DO NAS
    Strona główna
    Kody błędów
    VOLVO
    ECM-P128200
    VOLVO

    ECM-P128200 - Injector Control Pressure Higher Than Desired (engine running). General Failure Information. No sub type information

    Układ

    Sterownik silnika (ECM)

    Modele Volvo, których dotyczy ten kod błędu

    Dotyczy następujących modeli:

    8 modeli

    S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)

    Pokaż modele wg rocznika i silnika (8)
    • Volvo S60 (2011–)2014–2015Tylko silnik: D4204T5
    • Volvo S80 (2007–)2014–2015Tylko silnik: D4204T5
    • Volvo V40 (2013–)2015Tylko silnik: D4204T14
    • Volvo V40 Cross Country (2013–)2015Tylko silnik: D4204T14
    • Volvo V60 (2011–)2014–2015Tylko silnik: D4204T5
    • Volvo V70 (2008–)2014–2015Tylko silnik: D4204T5
    • Volvo XC60 (2009–)2014–2015Tylko silnik: D4204T5
    • Volvo XC70 (2008–)2014–2015Tylko silnik: D4204T5

    Co oznacza ten kod błędu?

    The engine control module (ECM) compares the fuel pressure on the high pressure side of the fuel system with the largest permitted deviation above the correct pressure. The correct pressure depends on engine load and speed. The check is only made with the engine running, and the code is set when the deviation is greater than permitted. It gives no further fault type.

    Możliwe przyczyny

    • The fuel flow control valve is damaged
    • The fuel pressure control valve is damaged
    • Air in the fuel system
    • Too high back pressure on the return side of the fuel system

    Co możesz zrobić

    1. 1Check the fuel level in the tank and top up if it is low.
    2. 2Look for leaks in the fuel system, such as wet spots or a smell of fuel at pipes and connections under the car.
    3. 3Deal with any fault codes for the fuel pump first.
    4. 4If you have a diagnostic tool, compare the measured and requested fuel pressure in live data at idle and at light throttle. The values should be close to each other.
    5. 5Have a workshop check the control valves, injector leakage, the fuel filter and the fuel pressure sensor wiring, as this needs measurements.

    Objawy, które możesz zauważyć1

    • Unusual noise while driving

    Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.

    OBD Tuning

    Wiodące centrum ekspertów Szwecji w elektronice motoryzacyjnej. Oferujemy profesjonalną optymalizację silnika, naprawę sterowników i diagnostykę z gwarancją 12 miesięcy.

    Usługi

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    Baza danych & Diagnostyka

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    Producenci ECU

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Firma

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    • Optymalizacja silnika
    • Naprawa sterownika
    • Klonowanie modułów
    • Zestaw wskaźników
    • SRS / Poduszka powietrzna
    • Immobilizer

    • Baza danych sterowników
    • Katalog kodów DTC
    • Przewodniki diagnostyczne & Pomiary
    • Analizator błędów AI
    • Aktualności

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • O nas
    • Kontakt
    • Partnerzy warsztatów
    • Przewodnik wysyłki
    • Gwarancja
    • FAQ
    • Regulamin
    • Polityka prywatności
    • Mapa strony

    Odwiedź nas

    Gjuterigatan 29, Karlstad

    Zadzwoń do nas

    054-830 480

    Napisz do nas

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Wszelkie prawa zastrzeżone.