VOLVO
ECM-P157000 - Intake Manifold Runner Control Circuit High. General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
8 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (8)
- Volvo S60 (2011–)2014–2015Tylko silnik: D4204T5
- Volvo S80 (2007–)2014–2015Tylko silnik: D4204T5
- Volvo V40 (2013–)2015Tylko silnik: D4204T14
- Volvo V40 Cross Country (2013–)2015Tylko silnik: D4204T14
- Volvo V60 (2011–)2014–2015Tylko silnik: D4204T5
- Volvo V70 (2008–)2014–2015Tylko silnik: D4204T5
- Volvo XC60 (2009–)2014–2015Tylko silnik: D4204T5
- Volvo XC70 (2008–)2014–2015Tylko silnik: D4204T5
Co oznacza ten kod błędu?
The swirl flap motor operates the flaps in the intake manifold, and its signal is monitored by the engine control module (ECM). The code is set when the PWM signal is wrong, and it is checked with the engine running.
Możliwe przyczyny
- Signal wire shorted to voltage
- Fault in the swirl flap motor
Co możesz zrobić
- 1Check that the fuses are intact. Their location is in the owner's manual or on the fuse box cover.
- 2With the ignition off, disconnect the connector to the swirl flap motor and use a multimeter to check that the signal wire is not shorted to voltage.
- 3Check the connector to the swirl flap motor for looseness and corrosion.
- 4If you have a diagnostic tool, activate the swirl flap motor and check that it responds to the command.
- 5If the fault remains, have a workshop check the swirl flap motor.
Objawy, które możesz zauważyć1
- No noticeable symptoms for the driver
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.