VOLVO
ECM-P161600 - Interactive Reprogramming Code - erase error, low voltage. General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
2 modeleS80 (2007–), V70 (2008–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The engine control module (ECM) has registered that the voltage was too low while its internal processor was being reprogrammed. The fault therefore relates to a programming step, and the cause is given as a software fault. The engine may be difficult to start and may feel short of power.
Możliwe przyczyny
- Software fault in the engine control module (ECM)
Co możesz zrobić
- 1Check the battery charge and that the battery terminals are tight and clean before any programming is done
- 2Read off the fault codes and note which are present
- 3Have a workshop reload the engine control module with the latest software and check that the fault code is gone
- 4After the reprogramming: switch the ignition on, start the engine and read off the fault codes again
Objawy, które możesz zauważyć2
- The engine is difficult to start
- The engine feels short of power
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.