VOLVO
ECM-P200500 - Intake Manifold Runner Control Stuck Open (Bank 2). General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
5 modeliS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (14)
- Volvo S80 (2007–)2007Tylko silnik: B6324S
- Volvo S80 (2007–)2008–2009Tylko silnik: B6324S, D4204T
- Volvo S80 (2007–)2010Tylko silnik: B6324S, B6324S2, D4204T
- Volvo S80 (2007–)2011–2015Tylko silnik: B6324S4, B6324S5
- Volvo V70 (2008–)2008–2009Tylko silnik: B6324S, D4204T
- Volvo V70 (2008–)2010Tylko silnik: B6324S, B6324S2, D4204T
- Volvo V70 (2008–)2011–2014Tylko silnik: B6324S5
- Volvo XC60 (2009–)2010Tylko silnik: B6324S, B6324S2
- Volvo XC60 (2009–)2011–2015Tylko silnik: B6324S4, B6324S5
- Volvo XC70 (2008–)2008–2009Tylko silnik: B6324S
- Volvo XC70 (2008–)2010Tylko silnik: B6324S, B6324S2
- Volvo XC70 (2008–)2011–2015Tylko silnik: B6324S4, B6324S5
- Volvo XC90 (2003–)2007–2010Tylko silnik: B6324S
- Volvo XC90 (2003–)2011–2014Tylko silnik: B6324S5
Co oznacza ten kod błędu?
The engine control module (ECM) checks the variable intake system by comparing the measured air flow with the expected air flow. The code is set when the lower secondary throttle unit is detected open, or when the brake control module (BCM) sends a signal that its information is incorrect. In the latter case the fault lies outside the intake system.
Możliwe przyczyny
- Damaged secondary throttle unit (lower)
- Fault in the brake control module (BCM), where the cause should be looked for
Co możesz zrobić
- 1If you have a diagnostic tool: activate the lower secondary actuator and check that the throttle unit moves
- 2Check the signal cable with a multimeter for an open circuit and a short circuit to supply voltage
- 3If the fault remains, have a workshop with diagnostic equipment read off the brake control module (BCM), as the cause may lie there
- 4If the brakes or ABS behave abnormally, have the car checked by a workshop before it is driven further
Objawy, które możesz zauważyć5
- The car performs worse and lacks power, especially at take-off
- The engine hesitates, surges or runs unevenly
- Check engine warning lamp lights or behaves abnormally
- Cruise control does not hold the set speed or cannot be engaged
- The ABS does not work or engages unexpectedly
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.