VOLVO
ECM-P200600 - Intake Manifold Runner Control Stuck Closed (Bank 1). General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
5 modeliS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (16)
- Volvo S80 (2007–)2007–2009Tylko silnik: B6324S, B8444S
- Volvo S80 (2007–)2010Tylko silnik: B6324S, B6324S2, B8444S
- Volvo S80 (2007–)2011Tylko silnik: B6324S4, B6324S5, B8444S
- Volvo S80 (2007–)2012–2015Tylko silnik: B6324S4, B6324S5
- Volvo V70 (2008–)2008–2009Tylko silnik: B6324S
- Volvo V70 (2008–)2010Tylko silnik: B6324S, B6324S2
- Volvo V70 (2008–)2011–2014Tylko silnik: B6324S5
- Volvo XC60 (2009–)2010Tylko silnik: B6324S, B6324S2
- Volvo XC60 (2009–)2011–2015Tylko silnik: B6324S4, B6324S5
- Volvo XC70 (2008–)2008–2009Tylko silnik: B6324S
- Volvo XC70 (2008–)2010Tylko silnik: B6324S, B6324S2
- Volvo XC70 (2008–)2011–2015Tylko silnik: B6324S4, B6324S5
- Volvo XC90 (2003–)2005–2006Tylko silnik: B8444S
- Volvo XC90 (2003–)2007–2010Tylko silnik: B6324S, B8444S
- Volvo XC90 (2003–)2011Tylko silnik: B6324S5, B8444S
- Volvo XC90 (2003–)2012–2014Tylko silnik: B6324S5
Co oznacza ten kod błędu?
The engine control module (ECM) controls the variable intake system dampers through a control valve that drives the vacuum motor, and reads the intake air pressure sensor to judge whether the system works. The code is set when the upper primary throttle unit is detected closed, that is, when the dampers have jammed in the closed position.
Możliwe przyczyny
- Damaged control valve
- Vacuum hoses disconnected from their connections
- Leaking or blocked vacuum hoses
- Sticking damper
- Damaged vacuum motor
- Damaged primary throttle unit (upper)
Co możesz zrobić
- 1Make sure every vacuum hose is properly attached to the control valve, the vacuum tank and the vacuum motor
- 2Listen for leaks and check that the hoses are not blocked
- 3Check that the dampers can move freely and that nothing is blocking them
- 4If you have a diagnostic tool: activate the upper primary actuator and check that it moves
- 5If the fault remains, have a workshop with diagnostic equipment check the control valve and the vacuum motor
Objawy, które możesz zauważyć3
- The car performs worse
- The car lacks power, especially at take-off
- The engine hesitates, surges or runs unevenly during acceleration, deceleration or steady speed
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.