VOLVO
ECM-P200817 - Intake Manifold Runner Control Circuit / Open (Bank 1). General Electrical Failures. Circuit voltage above threshold
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
5 modeliS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (6)
- Volvo S80 (2007–)2007–2009Tylko silnik: D5244T4, D5244T5
- Volvo V70 (2008–)2008–2009Tylko silnik: D5244T4, D5244T5
- Volvo XC60 (2009–)2009Wszystkie silniki oprócz: B6304T2
- Volvo XC70 (2008–)2008Wszystkie silniki oprócz: B6324S
- Volvo XC70 (2008–)2009Tylko silnik: D5244T4, D5244T5
- Volvo XC90 (2003–)2013–2014Tylko silnik: D5244T18, D5244T5
Co oznacza ten kod błędu?
The engine control module (ECM) monitors the swirl throttle motor circuit and sets the code when the signal is wrong. The code concerns a circuit voltage that is too high. This may be caused by a signal cable short-circuited to supply voltage, but also by an open circuit or a sticking swirl damper motor.
Możliwe przyczyny
- Signal cable short-circuited to supply voltage
- Open circuit in the signal cable
- Damaged swirl throttle motor
- Signal cable short-circuited to ground
- Swirl damper motor or linkage sticking
- Damaged linkage between the swirl throttle motor and the swirl throttle duct
Co możesz zrobić
- 1Check that the fuses are intact
- 2If you have a diagnostic tool: start the engine and read off the status of the code
- 3Check that the signal cable to the swirl throttle motor is not pinched or chafed
- 4Use a multimeter to check that the cable has no short circuit to supply voltage or ground
- 5If the fault remains, have a workshop check the swirl throttle motor and its connectors
Objawy, które możesz zauważyć1
- No noticeable symptoms for the driver
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.